a/d/s/ C80ic, C50ic, C62ic, C60ic Table of contents, Introduction, About this manual, Features

table of contents

introduction	1
cautions	1
about this manual	1
features	1
installation precautions and tips	2
general mounting suggestions	2
prewiring	3
preparing the wall or ceiling cutout	3
installation preparation	3
final installation	4
custom painting	4
operation	4
specifications	5
warranty information	6

introduction

Thank you for purchasing an a/d/s/ in-ceiling speaker system. Please read the following instructions carefully. Following these instructions will ensure that your system will deliver the best possible performance.

cautions

To reduce risk of injury because of an accident, be careful when working on a ladder or other high places.

about this manual

In-ceiling speakers can be used with many different receivers/televisions or amplifiers. They are designed to be powered by an amplifier with a minimum of 20 watts of power.

features

tweeter

The C series in-ceiling speakers incorporate a soft dome eyeball tweeter, which lets you aim and tune your system, Ferrofluid™ and has damped voice coils. Note that the C62ic model has a dual tweeter which is movable only in one axis. For this model attention to the the speaker orientation during mounting is required so that the system can be tuned for maximum audio enjoyment.

tweeter protection

A solid state device reduces power to the tweeter when the loudspeaker is operated at unsafe power levels. It resets automatically when power is reduced to a safe level. Note: the tweeter protector provides a significant level of protection. However it does not guarantee that the tweeter cannot be damaged. Always be careful when operating the speakers at a high volume level.

woofer

The polypropylene woofer employs a barium ferrite magnet structure for well damped, extended bass and high efficiency.

installation precautions and tips

Please read these instructions completely for the best enjoyment of your Custom Series speakers.

When you cut into the ceiling to install the speaker, do not cut through the facing or insulation that

2