Alesis Monitor One manual Specifications and Service

CHAPTER 3: SPECIFICATIONS AND SERVICE

3.0 SPECIFICATIONS

Drivers:	6.5" low frequency, 1"
	silk dome high frequency
Crossover:	2.5 kHz, 2nd-order filters
	(12 dB per octave)
Frequency Response:	45 Hz - 18 kHz, ±3
dB
Power Handling:	120 watts program, 200
	watts peak (using EIA-
	426A method)
Nominal Impedance:	4 ohms
Sensitivity:	88 dB SPL @ 1 watt and
	1 meter on axis
Cabinet:	Rubber textured laminate
	over 5/8" MDF with
	Alesis SuperPort on rear
Dimensions:	15"W x 9.25"H x
8.5"D
Weight:	15 lb. each

3.0A Architectural and Engineer's Specifications

The loudspeaker cabinets shall each contain a 6.5" low frequency and a 1" silk dome high frequency driver, and be equipped with a passive crossover network with a crossover frequency of 2.5 kHz.

The low frequency driver shall have a mineral-filled polypropylene cone, a damped linear rubber surround and a 1.5" diameter voice coil wound on a high-temperature Kapton former. The high frequency driver shall be ferrofluid cooled. The crossover network shall consist of a low-pass section feeding the 6.5" driver and a high-pass section connected to the 1" driver, with 2nd-order filters in each section using low dielectric loss non-polarized capacitors and an oversized low-loss low frequency inductor. Each cabinet shall be equipped with two 5-way binding posts for electrical connection to an amplifier recessed into the back of the cabinet. These posts shall accept heavy-gauge wire, standard banana plugs, or spade lugs.

The cabinet shall be constructed of 5/8" thick MDF and be

10