VideoEdge ™ NVR Bundled Server
1What’s in the Box
Standard Items
2 x Localized Power Cords | Rack Mounting Kit | USB Keyboard |
VideoEdge™ NVR Bundled Server
Quick Setup Guide and VideoEdge™ NVR Installation Disc.
NOTE: Store the VideoEdge™ NVR CD and jewel case in a safe place. The serial number printed on the label is your proof of license to use the software.
2Required Accessories (not in this box)
VGA or Flat Panel Monitor (not shown)
PC with Internet Browser and Network Connection (not shown) Supported IP Cameras or VideoEdge™ IP Encoders Gigabit Ethernet switches and cabling
IP Encoder | IP Network Camera | Gigabit Switch |
3Optional Accessories for Extended Storage
American Dynamics Fibre Host Bus Adapter (HBA) Kit* American Dynamics Fibre RAID Storage System*
*Contact your American Dynamics Representative for more information.
4Panel Connectors
Back Panel
Connect both Power Cords
Optional: Connect the Fibre RAID
Storage Unit
Note: The Fibre HBA Kit is required and sold separately*
Connect Gb 2 (LAN2) to Camera Network
Use proper network switch
Connect Gb 1 (LAN1) to Client Network
Use proper network switch or
Connect the USB Keyboard
Connect the VGA Main Monitor
Connect to blue female connector
Connect Power and additional cables as indicated above
Be sure to use an Uninterruptible Power Supply (UPS)
Be sure to use surge protection for power supply and provide appropriate grounding
VGA Monitor and peripherals should be powered up before the unit is powered up
Always follow appropriate safety precautions
Unit powers up when you press the Power button on the front panel
5Power Up and Test
The unit should power up as soon as you press the Power button on the front of the unit.
Power button |
|
|
|
|
|
|
|
|
| LCD Panel |
Reset button
Observe the boot sequence on the VGA monitor.
On the client computer launch the Internet browser and enter the IP address of the VideoEdge™ NVR Bundled Server.
6Results
The VideoEdge™ NVR Bundled Server should be powered up and running. The VideoEdge™ web page should be displayed on the client PC.
Is the Unit Functioning as Described?
YES!
The VideoEdge™ NVR Bundled Server is ready to be licensed and configured.
Use the following information to log in: |
|
Default Username: admin | Default Password: admin |
You must now register the VideoEdge(tm) NVR Bundled Server to license the NVR, complete the installation and configure the network, users/groups and camera configuration settings. For details refer to the User Manual on the VideoEdge™ NVR Installation Disc.
NOTE: The registered camera license file must be applied to the
VideoEdge™ NVR Bundled Server before the temporary license period expires.
CAUTION: Do not boot the VideoEdge™ NVR Installation Disc on your desktop computer. Booting from this disc removes all data from the primary hard disk.
NO!
Is the VideoEdge™ NVR Bundled Server powered up?
Check the power connections.
Did you see the boot sequence on the VGA monitor?
If not, power the VideoEdge™ NVR Bundled Server off and restart. You may need to
Can you connect with a browser?
If not, verify the IP address is correct by using the ping command from a Command Prompt window. Verify the network connections, IP addresses and subnet masks on the client.
If you have checked all these items and the unit fails to power up, or you repowered your unit and the unit still fails to operate properly, please contact your American Dynamics Representative.
© 2008 Tyco International Ltd. and its Respective Companies. All Rights Reserved