INSTALLATION INSTRUCTIONS
BEFORE YOU BEGIN INSTALLATION:
Before drilling, be sure that no cable or wiring is on the other side. Clamp all wires securely to reduce the possibility of them being damaged during installation and use. Keep all cables away from hot or moving parts, and electrically noisy components.
Wiring Definitions: |
|
|
? Power connection: | Pin 1 | ACC +12V (Red) |
| Pin 2 | Standby Trigger (Blue wire) |
| Pin 3 | Ground (Black wire) |
| Pin 4 | Audio Trigger (Blue w/white stripe wire) |
? Camera A input: | Connection for camera or camera extension cable | |
? Camera B input: | Connection for camera or camera extension cable | |
? LCD panel: | ||
Procedure:
1.Choose the monitor, junction box, and camera mounting locations.
2.Install all required cables in vehicle. A ¾” (19mm) hole should be drilled for passing cables through vehicle walls, barriers, etc. After the intermediate cable is passed through the hole, install the split grommet (included). If additional cable protection is required install convoluted tubing over the cable.
3.After cable/wiring has been routed and components are in place, temporarily make all system connections and perform a system function check. If system does not operate properly, see the troubleshooting section of this manual.
4.If using an optional PanaVise? stalk mount (available separately), use the mounting template provided on page 10. Install the PanaVise? mount to the LCD monitor using the #10
**Important: Do not use screws other than those provided with the AOM681. Void of warranty and serious product damage will occur.
5.Use the template provided on page 10 for proper placement of the junction box mounting holes. Use the #8
6