Setting Up Dolphin 9500 Series Terminals
1.Unpack the carton and verify its contents - page 4.
2.Install the battery in the terminal - page 4.
3.Charge the main battery in the terminal for a minimum of four hours - page 4.
4.Initialize the terminal - page 5.
Step 1: Install the Main Battery Pack
Use only the
!battery pack not sold/manufactured by Hand Held Products in the Dolphin 9500 Series terminal will void your warranty and may result in damage to the Dolphin terminal or battery.
Remove the Dolphin 9500/9501 Hand Strap | Hand Strap |
Dolphin 9500/9501 terminals ship with the |
|
hand strap installed and fastened with a clip on |
|
the bottom panel. | Clip |
Push the clip of the hand strap down and away from the terminal. Move the strap up and away from the bottom panel.
To
Install the Battery
1. Remove the
2. Hold the terminal with the front panel (keyboard) facing down.
3. If necessary, detach the hand strap.
4. Take the battery and insert the end without
the locking tab into the top of the battery well and push down with a hinging motion until the locking tab snaps.
5. If necessary,
To remove the battery pack, detach the hand
strap, press the locking tab on the battery pack away from the bottom panel, and pull the battery pack up with a hinging motion.
Step 2: Charge the Main and Backup Batteries
The power supply consists of two types of battery power: the main battery pack installed in the back panel and the backup battery located inside the terminal.
The main battery powers the terminal and charges the internal backup battery. The internal backup battery maintains the data stored in RAM memory and the keeps the system clock running for up to 30 minutes when the main battery is completely discharged or removed.
4 | Dolphin® 9500 Series Mobile Computer Quick Start Guide |