
Appendix
1.Operation Mode:
USB Wireless Lan Card has two modes, ‘Infrastructure’ and
“Infrastructure”.
(Please refer to the Product Introduction)
2.Channel:
The channel setting should follow the regulation of the local government. For ‘Infrastructure’ mode, the channel does not need to be set. It will automatically change to the same channel as AP’s. In
3.SSID:
When STA (WLAN card) is in
Important: Capital and
4.Tx Rate:
It determine STA’s transmitting rate. There are 5 rated to choose, 1, 2, 5.5, 11Mbps, and Auto. The default setting is “Auto”.
5.Int. Roaming: Its default setting is ‘Disable’, and does not need to be adjusted.
6.Radio:
The default setting is ‘ON’. It means to stop the STA’s RF function. If your WLAN card is embedded, you can stop its function by turning the Radio “ON”.
7.Encryption:
USB Wireless Lan Card provides 64/128bits encryption. Choose “disable”, if you do not need this function.
When using Encryption, there are two configurations to setting: Choose from encryption key 1~4 to encrypt.
For 64bits encryption:
Using letters & numbers: 5 digits
Hexadecimal: 10 digits
Using letters & numbers: 13 digits
Hexadecimal: 26 digits
Choose the Authentication type from open system, share key, and auto type. The default setting
USB Wireless LAN Card | 11 |