You may find two screw holes on back of the right side of the main unit of Jiva series or TM4000 series or the like. Just align the upgrade unit on the right edge of the main unit after removing these 2 screws then replace them with the attached 2 screws and fasten them with washer as indicated in the picture below.
|
| The Upgrade Kit | |
Upgrade Unit Screw Hole | |||
|
| ||
|
|
|
Back of Jiva Series 
CABLE CONNECTION
Connection To Host
KB4000 | KP100 | SD100 |
PS/2 KB Connector | USB Connector Special MSR Connector |
Please refer to the pictures above. The USB connector could be absent from the product if the product is purchased without the smart card reader and the finger print scanner or if it is SD100 with only the special type of MSR (instead of the USB interface MSR) or the iButton receptor. The MSR connector
KB4000 Series User’s Manual | 2 - 2 |