Easy Setup Proﬁle | Netopia 3366C-ENT guide

Easy Setup 6-5

2. Easy Setup Proﬁle

The Easy Setup Proﬁle screen is where you conﬁgure the parameters that control the Netopia 3366C-ENT’s connection to a speciﬁc remote destination, usually your ISP or a corporate site. On a Netopia 3366C-ENT you can add up to 15 more connection proﬁles, for a total of 16, although you can only use one at a time, unless you are using Virtual Private Networks (VPNs).

Connection Profile 1: Easy Setup Profile

	+--------------	+
Underlying Encapsulation...	+--------------+
RFC1483 Mode...	Bridged 1483
	Routed 1483
	+--------------	+
Address Translation Enabled:	Yes
IP Addressing...	Numbered
Local WAN IP Address:	0.0.0.0
Local WAN IP Mask:	0.0.0.0

	Connection Profile 1: Easy Setup Profile
Underlying Encapsulation...		None
PPP Mode...		VC Multiplexed
PPP Authentication...		None
Address Translation Enabled:		Yes
IP Addressing...		Numbered
Local WAN	IP Address:	0.0.0.0
Local WAN	IP Mask:	0.0.0.0
Remote IP	Address:	127.0.0.2
Remote IP	Mask:	255.255.255.255

PREVIOUS SCREEN

NEXT SCREEN

PREVIOUS SCREEN

NEXT SCREEN

Enter basic information about your WAN connection with this screen.

If you selected RFC1483 in the previous screen, the Easy Setup Proﬁle screen allows you to choose PPPoE or None as the Underlying Encapsulation.

•If you choose None, the RFC1483 Mode offers the choice of Bridged 1483 or Routed 1483.

•If you choose PPPoE, a PPP Authentication option appears, to permit you to select PAP or CHAP authentication (or None), and ﬁelds to enter PAP User Name and Password, or CHAP

Host Name and Secret.

If you selected PPP in the previous screen, the Easy Setup Proﬁle screen allows you to choose PPPoE or None as the Underlying Encapsulation.

•If you choose None, the PPP Mode offers the choice of VC Multiplexed or LLC SNAP.

•The PPP Authentication option permits you to select PAP or CHAP authentication (or None), and ﬁelds to enter PAP User Name and

Password, or CHAP Host Name and Secret.

1.To enable address translation, toggle Address Translation Enabled to Yes (the default). You need not change this unless you have a speciﬁc reason. For more information on Network Address Translation, see the Firmware User’s Guide chapter on “Multiple Network Address Translation (MultiNAT)“.

2.Depending on your Data Link Encapsulation selections, either Numbered or Unnumbered IP Addressing may be enabled by default. (You may choose either from the pop-up menu, if speciﬁcally instructed to do so.) Unless otherwise speciﬁed by your service provider, accept the defaults, and do not change the next two values. They will be supplied by your ISP.

3.Press the Down arrow key until you reach NEXT SCREEN. Press Return to bring up the next screen.

Netopia 3366C-ENT manual Easy Setup Proﬁle

Easy Setup 6-5

2. Easy Setup Proﬁle