Milnor KXMIC00155 manual Micro 6 Systems Processor with CGA Interface

2

NOTES:

1.EPROMS MUST BE INSTALLED IN THE CORRECT SOCKET FOR THE MACHINE TO OPERATE. THE TOTAL NUMBER OF EPROMS MAY VARY. EACH EPROM IS NUMBERED 1,2,ETC

a. IF THERE IS 1PROM-INSTALL IN SOCKET IC29.

b. IF THERE ARE 2 EPROMS-INSTALL #1 EPROM IN SOCKET IC30 AND #2

EPROM IN SOCKET IC29.

c. IF THERE ARE 3 EPROMS-INSTALL #1 EPROM IN SOCKET IC63, #2 IN SOCKET IC30, AND #3 IN SOCKET IC29

d. IF THERE ARE 4 EPROMS-INSTALL #1 EPROM IN SOCKET IC64, #2 IN SOCKET IC63, #3 IN SOCKET IC30, AND #4 IN SOCKET IC29.

2.MAKE SURE THAT ALL PINS ARE IN THEIR HOLES WHEN INSERTING (BE CAREFUL NOT TO BEND PINS UNDER CHIP.)

KEYPAD

DISPLAY

INPUTS

1MTA39 1MTA38 1MTA36 1MTA37 1MTA40 1MTA35

	CABLE
BBVI	TO MONITOR
	J1
INTERFACE
BOARD

	W1	1MTA31	POWER
	EDGE CARD
	CONNECTOR
BPB
		2MTA31	BATT.
MUST BE
PROCESSOR BOARD
EPROMS
INSTALLED	IC29	1MTA32	#1
WITH NOTCH	IC30
IN POSITION
SHOWN.	IC63
EPROMS IC64		1MTA33
			#2	RS485
SEE NOTE
		1MTA34	#3
		1MTA30	RS232#4

MICRO 6 SYSTEMS

8088 PROCESSOR WITH CGA INTERFACE

PELLERIN MILNOR CORPORATION	B2TAG95001
	95027G