Marshall electronic V-R653-IMD-TE Rear Panel Features, HD-SDI Input and Output

Page 6

Rear Panel Features

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

IN OUT

IN OUT

IN OUT

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

HD-SDI Input and Output

Each screen has one HD-SDI input and one active loop-through output. Note: No more than 4 screens should be connected in one loop.

Power Input

Connect the 12VDC input to the 2-Pin twist lock power input connector. Power can be supplied from the included power supply, or from a variety of DC sources supplying at least 6.0 Amps at 12 Volts.

IMPORTANT: If using a power source other than the included power supply, be sure that the polarity of the DC input is correct:

Tally Interface (HD-15)

Both LED tally and OSD tally can be activated via the HD-15 connector by connecting the corresponding pin to ground. A variety of external devices can be used to perform the contact closure. No additional power should be supplied to the HD-

15port. See pin-out details on page 26.

RS-422/485 Serial Interface

The RS-422/485 ports are used to remotely control the IMD or all V-R653-IMD-TE features, using a variety of industry standard protocols. (Note:

Connector/pin-out may need to be adapted depending on protocol and controlling device used. See pin-out details on page 26.) Only one connection to either port is needed to control the monitor. The second port can be used to loop multiple monitors in the same bus.

6

Image 6
Contents Operating Instructions Contents Features Product OverviewConnections, Power-On and Initial Setup Installation and Initial SetupInstallation UnpackingTop and Front Panel Features Power ButtonRear Panel Features HD-SDI Input and OutputCompatible Input Formats On-Screen MenuStructure Overview On-Screen Menu Main Menu and NavigationMarker Setup Submenu MarkersMarker Setup Submenu Marker BackgroundCenter Marker Video Configuration Submenu Monochrome ModeBlue-Only Mode Video Configuration Submenu Pixel-to-Pixel ModeAspect Ratio Settings Curtain Color Red, Green, and Blue Offset Color Configuration SubmenuCtemp/Gamma Red, Green, and Blue GainSystem Configuration Submenu Gray LevelsUser-Definable Function Buttons Save Defaults System Configuration SubmenuSaving and Loading User Presets Software Version DisplayDeinterlacer Mode Deinterlacer SubmenuDeinterlacer Submenu Film ModeFilm Indicator Motion DisplayOSD Configuration Submenu IMD StateStatus Display OSD Configuration Submenu OSD TallyLED Tally Time CodeAudio Monitor IMD Configuration Submenu OverviewIMD Protocol IMD Configuration Submenu IMD Tally Mode Tally SourceService Submenu CRCSpecifications PanelScreen Cleaning MaintenanceWarranty Faceplate DustingMarshall Electronics, Inc