A929 CPU installation Guide
Notice:
This machine has been tested and found to comply with the standards set forth by the Quality Control. All parts of the machine had undergone
Please follow the steps below on how to install the CPU. The manufacturer will not be responsible for any direct, indirect, special, incidental or consequential damages arising from any defect and improper installation of the CPU.
CPU Installation Procedure:
Step1:
Before you begin, gently place the machine upside down. Loosen the three screws to open the CPU compartment:
Step 2:
Following figure ,
head to the gap and gently shift the screw to a
push the lock clip of the CPU socket to release it.
Use the screwdriver to
unlock the opposite side
as shown in figure . Insert the screwdriver
Step3:
Orient the CPU so that pin 1 on the chip corresponds to pin 1 (pinhole missing) on the CPU socket. Insert the processor into the socket.
Step 4:
For the opposite side, repeat the procedures
indicated on | Step 2 of |
figure and | . |
Step5:
Then, lock the CPU socket. The figure shows the direction for locking the CPU socket.
Step 6:
Put the heatsink over the CPU and tighten all four screws on each side. Then place back the CPU compartment and secure with three
screws.This
completesthe installation for the CPU.
***The 4 screws are specially designed for the heatsink, do not use force or over- tighten the screws as this may distress or damaged it.
1