Porter-Cable 223EI user manual Service, Return to TOP

Safety and Troubleshooting Information

●Do not store or use the LCD monitor in locations exposed to heat, direct sunlight or extreme cold.

●In order to maintain the best performance of your monitor and use it for a longer lifetime, please use the monitor in a location that falls within the following temperature and

humidity ranges.

￿❍ Temperature: 0-40°C 32-95°F

￿❍ Humidity: 20-80% RH

●IMPORTANT: Always activate a moving screen saver program when you leave your monitor unattended. Always activate a periodic screen refresh application if your LCD monitor will display unchanging static content. Uninterrupted display of still or static images over an extended period may cause “burn in”, also known as “after-imaging” or “ghost imaging”, on your screen. "Burn-in", "after-imaging", or "ghost imaging" is a well- known phenomenon in LCD panel technology. In most cases, the “burned in” or “after- imaging” or “ghost imaging” will disappear gradually over a period of time after the power has been switched off.

WARNING: Severe” burn-in” or “after-image” or “ghost image” symptoms will not disappear and cannot be repaired. The damage mentioned above is not covered under your warranty.

Service:

●The casing cover should be opened only by qualified service personnel.

●If there is any need for any document for repair or integration, please contact with your local service center. (please refer to the chapter of "Consumer Information Center")

●For transportation information, please refer to "Physical Specifications".

●Do not leave your monitor in a car/trunk under direct sun light.

Consult a service technician if the monitor does not operate normally, or you are not sure what procedure to take when the operating instructions given in this manual have been followed.

RETURN TO TOP OF THE PAGE

file:///E/LCD%20Monitor%20OEM/Philips/M1-project/223E1/223E1-EDFU/5B.10N01.001/CD-Contents/lcd/manual/ENGLISH/223E1/safety/safety.htm 第 2 頁 / 共 2 [98-07-30 15:20]