Waves EQP-1A user manual High Shelf Atten Range

Page 11
High Shelf Atten

High Shelf Atten

Range

0 to 11 (18dB attenuation, 0.1 steps)

Default

0

High Shelf Frequency (Atten Sel)

Range

5kHz, 10kHz, 20kHz

Default 20kHz

In turns the EQ on/off but leaves the analog modeling.

Range

On/Off

Default

On

Mains controls analog characteristics caused by noise floor and hum, based on the power supplies of the original units.

Range

Off, 50Hz, 60Hz

Default

60 Hz

Gain controls the trim level.

Range

-18dB to +18dB (in 0.1dB steps)

Default

0dB

Meter displays output level in dBFS. The LED located in the upper right corner lights up when output signal is clipping.

Waves PuigTec EQP-1A User Manual

11

Image 11
Contents EQP-1A Waves PuigTecTABLE OF CONTENTS 1.1 Welcome Chapter 1 - IntroductionABOUT PULTEC 1.2 Product OverviewTransformers 1.3 About the ModelingTotal Harmonic Distortion HumPage 1.4 Components Chapter 2 - Quickstart Guide 3.1 PuigTec EQP-1AInterface Chapter 3 - Interface and Controls3.2 PuigTec EQP-1AControls High Shelf Atten Range 4.1 The WaveSystem Toolbar 4.2 Preset HandlingPreset Types Chapter 4 - The WaveSystemSave to New File… Loading Presets and SetupsSaving Presets and Setups Put into Preset Menu As…Toggle Buttons Deleting Presets4.3 Interface Controls A/B Comparison and CopyingMultiple Selection of Controls Value Window ButtonsSliders Hover BoxTAB Functions Range Appendix A - PuigTec EQP-1AControlsDefault Control