ATX6 Installation and User Guide

Hours

(00 ~ 12 AM/PM)

Use the INC button to advance through the values. Advancing past ‘11’ will also toggle the AM and PM indicators. Press the SET button when the correct value is displayed.

Minutes

(00 ~ 59)

Use the INC button to change the value of the first digit. Use the NXT button to move the cursor to the next digit, and then use the INC button to change the selected digit. Press the SET button when the correct value is displayed.

Press SET after this step to set seconds to :00. For the most precise manual time setting, increment the displayed value to represent the up-coming minute. Then, at the start of the new minute, press the SET button to record the programmed MM-DD-YY HH:MM:00.

Parameter Set-Up:

To enter the Parameter Set-Up Mode, simultaneously press the Left (INC) and Center (NXT) buttons for 1 second. You will see the Password prompt: “P000”. For each of the following parameters to be set, the display will show the parameter number in the two left digit positions, and the parameter value in the two right digit positions. The parameters are as follows:

Awaiting Password

(000 ~ 999)

If you have not previously changed the password, press the SET button to continue [Default Password is ‘000’]. If you have previously changed the Password, enter the value using the INC, NXT and SET buttons. The INC button will increment the digit over the displayed cursor. The NXT button will move the cursor to point to the next digit. The SET button will enter your final selection. If correct, the display will advance to enter the first set-up parameter.

If incorrect, an “Err” message will be displayed. Press the Set button to re-enter your password. Press Inc or Next to abort the setup.

Page 8