Daylight Saving Time

•Press “SET” to confirm your setting, the Date display starts to flash. Now use “▲” and “▼“ buttons to set the correct date. Weekday will set itself if the clock has received the WWVB signal.

•Press “SET” to confirm your setting, the DST icon starts to flash. Now use “▲” and “▼“ buttons to turn Daylight Saving Time on ("on") or off ("oF"). See "Daylight Saving Time" below for more information.

•Press “SET” to confirm your setting and to end the setting procedures, enter the clock mode.

•The National Institute of Standards and Technology and WWVB encode a special DST “bit” in the WWVB transmission for DST.

•Your La Crosse Technology® clock will read this information (only if "DST" is set to "on" -) and automatically advance the time one hour in the spring and back an hour in the fall.

•Arizona: If you live in an area that does not recognize DST you must de-activate Daylight Saving Time by setting "DST" to "oF"

Setting the Time Zone:

•Press the “▲” button to set the correct time zone. It will toggle the clock mode through the four available time zones in the Continental U.S. Above the seconds digits, the LCD display will indicate "P" for Pacific, "M" for Mountain, "C" for Central and "E" for Eastern.

•After 30 seconds without pressing any button, the clock switches automatically from set mode to normal time mode.

Setting the Daily Alarms:

•To turn the alarm on, press the ALARM button. LCD displays the “” icon.

Page 5 of 12