La Crosse Technology WS-6003U II Indoor Temperature, Mounting, Foldout Table Stand

Page 8

3)Press and release the “+” button a third time and the display will return to the normal display.

II)INDOOR TEMPERATURE

The Indoor Temperature appears on the right side of the Date LCD. The temperature is checked every 10 seconds, and updated whenever there is a change.

MOUNTING

Hanging Holes

Function Buttons

Foldout Table Stands

SET

There are two possible ways to mount the atomic clock:

•use of the foldout table stands, or

•wall mounting.

I)FOLDOUT TABLE STAND

The foldout table stand leg is located on the backside, directly below the battery cover and function buttons. The hinge is towards the center of the atomic clock, and the end (with no hinge) needs to be folded in towards the

center. Once the foldout table stand is extended, place the atomic clock in an appropriate location.

II)WALL MOUNTING

1)Using a straightedge, horizontally space at 3-15/16 of an inch (100.58mm) three screw positions on a wall.

2)Install three mounting screws (not included) into a wall within transmission range—leaving approximately 3/16 of an inch (5mm) extended from the wall.

8

Page 7 Page 9
Image 8
Page 7 Page 9
Contents WS-6003U Atomic Clock Table of Contents Quick SET-UP Guide Inventory of ContentsDetailed SET-UP Guide Battery Installation Atomic Clock Program Mode Function Buttons II Time Zone SettingIII DST Daylight Saving Time Setting IV Language Selection for the Weekday Time SettingVI Calendar Setting VII 12/24-HOUR Setting Viii Selecting F or CII Indoor Temperature MountingFoldout Table Stand II Wall MountingMaintenance & Care TroubleshootingProblem SolutionSpecifications TemperaturePower source Dimensions L x W x HWarranty Information
Top Page Image Contents