PSC LR, XLR manual Installation, Power Supply

Installation

Refer to Figure 1 and follow these steps to install the scanner:

Consult your host terminal manual to determine if power must be turned off before connecting peripheral devices such as the scanner.

1.Should you need to disconnect the interface (I/F) cable from the scanner, loosen the Phillips head screw at the bottom of the handle and rotate the cable restraint clip away from the cable to release it. Reverse this procedure to connect the cable.

Do not attempt to pull the End Cap off, as this may damage the scanner.

CAUTION

2.Connect the I/F cable to the proper port on the host terminal.

3.If your system requires an AC/DC adapter to power the scanner, connect the adapter's power cord at the I/F connec- tor. (Note: In most cases, the scanner uses Power Off the Ter- minal [P.O.T.], and does not require this step.) Contact your PSC dealer if you’re not sure if an AC/DC adapter should be used with your system.

4.Connect the AC/DC adapter at the wall outlet. (P.O.T. units skip this step.)

5.Verify operation—point at a flat surface and pull the trigger. A red beam should be visible. Scan a sample bar code and confirm that the scanner reads the bar code by beeping and/ or sending the data to the host terminal.

Power Supply

The scanner requires either a Listed Class 2 or Listed LPS power source which supplies power directly to the scanner.

4 PowerScan™ Scanner