Printek Mt2 Series manual Tearing Off a Print Job, Operation, Tearing the Paper

Operation

•Verify that the printer is turned off.

•Press and hold the PAPER FEED button.

•While continuing to hold the PAPER FEED button, press the ON/OFF button to turn the printer on.

•The printer will start printing the self-test messages. You may now release both buttons.

•The Self-Test will stop after all the printer information is printed, or you may press either the ON/OFF Button or the PAPER FEED Button to cancel the Self-Test.

The first few lines of self-test show the printer firmware version, the current printer settings (for example IrDA or Serial/Bluetooth mode) and a list of any optional or special features installed.

Tearing Off A Print Job

The edge of the printer’s paper door acts as a tear bar. Pull one edge of the paper against the tear bar at an angle as shown below, and then tear down and across against the tear bar to tear the paper.

Note that using the tear bar is the only way to tear the paper. Pulling up or pulling sideways without using the tear bar can cause a paper jam due to paper misalignment in the print head mechanism.

Tearing the Paper

8