Important Safety Instructions

DANGER: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,

CAREFULLY FOLLOW THESE INSTRUCTIONS.

WARNING: This unit should not be directly connected to a battery for charging or for battery back-up. Battery charging and battery back-up may be undertaken only when the battery is connected through suitable external isolating diodes and charge limiting resistor. The isolating didode will ensure that battery does not back power the power supply. When a battery is deeply discharged, it will initially draw a very large charging current and force the power supply into current limit mode for prolonged periods. This is harmful for the power supply. The charge limiting resistor will limit the charging current to ensure the maximum charging current is well below the current limit value of the power supply.

This manual contains important safety and operating instructions for this power supply. Before you use the power supply, read all the instructions and cautionary markings in this manual, on the power supply, and on the product that you will connect to the power supply, to reduce the risk of injury:

•Do not use the power supply near water(for example, a bathtub, washbowl, kitchen sink, laundry tub, wet basement, or swimming pooi).

•Do not place the power supply on an unstable cart, stand or table. If the power supply falls, it could injure a person or cause serious damage to the power supply.

•Do not overload power outlets or extension cords. An overload can result in fire or electric shock.

•Do not use an extension cord unless absolutely necessary. Using animproper extension cord could result in a risk of fire and electric shock. If an extension cord must be used, make sure:

a.The pins on the extension cord's plug are of the same number, size, and shape as those of the plug on the charger.

b.The extension cord is properly wired and in good electricai condition.

c.The extension cord's wier size is at least 18 AWG.

•Do not disassemble the charger; take it to a qualified service technician when service or repair is required. Improper reassembly may result in a risk of electric shock or fire.

•Do not use an attachment not recommended, this could result in a risk of fire,electric shock, or injury to persons.

•Never push any object into the slot in the power supply. It could touch dangerous voltage points or short out parts resulting in a fire or electrical shock.