Trilogy Touch Technology T3-HB17A1 Conformity and Compliance, Canadian DOC Notice, Energy Star

Page 15

CONFORMITY AND COMPLIANCE

FCC Compliance Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential installation. This device generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this device does cause harmful interference to radio or television reception (this can be determined by turning, the device off and on), you are encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Caution

To comply with the limits for an FCC Class B computing device, you should use the shielded signal cord and shielded power cord supplied with this unit. The Federal Communication Commission warns that changes or modifications of the unit not expressly approved by the

party responsible for compliance could void the user’s authority to operate the equipment.

RADIO FREQUENCY INTERFERENCE STATEMENT

Warning:

This is a Class B product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.

CANADIAN DOC NOTICE

For Class B Computing Devices

This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set out in the Radio Interference Regulation of the Canadian Department of Communications.

CE MARKING DECLARATION OF CONFORMITY

This LCD Monitor complies with the requirements of related European standards, which include:

Emission: EN 55022, EN 61000-3-2, EN-61000-3-3

Immunity: EN 50082-1

Safety: EN 60950 [Low-Voltage Directive (73/23/EEC)

ENERGY STAR

This product meets the Energy Star guidelines for energy

efficiency.

Page 12

Image 15
Contents Page Table of Contents Page Introduction FeaturesAccessories Included Getting StartedSystem Requirements Using Touch InputConnecting the Monitor Installing the MonitorOperating the Monitor Additional Information about the on SCREEN-DISPLAY HOW to USE the OSD on Screen DisplayOperating Procedure To Make OSD AdjustmentsSELF-TEST Check Menu Table For Your Safety Cleaning CabinetDisplay Area Sensor Supported Timing Power ManagementTroubleshooting Procedures LEDProblem Check to see CE Marking Declaration of Conformity Conformity and ComplianceRadio Frequency Interference Statement Canadian DOC NoticePortsmouth, NH Product Service and SupportContact Information Mailing Address Trilogy Touch TechnologiesTrilogy Touch Technology Touch Monitor Limited WarrantyLimited Warranty Warranty Limitation Exclusion Exclusive RemediesTrilogy Service Policies Chassis Monitor T3-HB17A1 Dimension Drawing