Trilogy Touch Technology Trilogy Touch Monitor For Your Safety, Cleaning, Power Management

FOR YOUR SAFETY

WARNING

ALWAYS OPERATE UNDER KNOWN POWER SUPPLY

∙Usage of incorrect voltage will cause malfunctions and may cause fire or electric shock.

PROTECT AND CORRECTLY USE THE SIGNAL CABLES

∙Do not pull or bend the power cable and signal cable or place the monitor or any heavy

objects on the cables. If the cables are damaged, they may cause fire or electric shock.

IMMEDIATELY STOP OPERATING THE MONITOR WHEN YOU DETECT ANY ABNORMAL OCCURRENCES

∙If you notice any abnormal phenomenon such as strange noise, smoke or smells, unplug the monitor and contact your dealer or the nearest service center immediately.

DO NOT REMOVE THE CABINET

∙Removing the cabinet may expose you to the danger of fire or electric shock. Opening the product will void the warranty.

DO NOT PUT ANY FOREIGN OBJECT INSIDE THE MONITOR

∙Modification of this product may result in improper operation as well as voiding the warranty.

DO NOT USE THE MONITOR NEAR WATER

∙Operating the monitor in close proximity to water where the water may enter the device may cause fire or electric shock.

BAD WEATHER CONDITIONS

∙It is advisable not to operate the monitor during heavy thunderstorms as intermittent breaks in power may cause malfunctions. Do not touch the plug under these circumstances as it may cause electric shock.

CAUTION

DISCONNECT CABLES WHEN MOVING THE MONITOR

∙When moving the monitor, always turn off the power, unplug the monitor, and disconnect the signal cables.

DO NOT TOUCH THE ELECTRICAL CONNECTIONS WITH WET HANDS

∙Pulling or inserting the plug with wet hands may cause electric shock.

HOLD THE PLUG WHEN DISCONNECTING

∙To disconnect the power cable or signal cables, always pull the cables by the plug. Never pull on the cable as this may cause fire or electric shock.

OTHER CONSIDERATIONS

Ergonomics Recommendations

Do not operate the monitor in a dark room or against a bright background. For optimal viewi ng comfort, the monitor should be just below eye level and 30-60 cm (16-24 inches) away from your eyes. When using the monitor over a prolonged period of time, a ten-minute-break per hour is recommended.

8

SPECIAL NOTES ON LCD TOUCH MONITORS

The following are normal with LCD Touch Monitors and do not indicate a problem.

•When the LCD Touch Monitor is first powered on, the picture may not fit in the display area. This is because of the type of computer graphics system that is used. In such case, adjust the picture position to a desired image (See Operating the Monitor).

•The screen may flicker during initial use. Turn off the power and then turn it on again the flickering should disappear.

•Users may notice some uneven brightness on the screen depending on the desktop resolution they use. It is normal for LCD Touch Monitors to show uneven brightness.

•Due to the nature of the LCD displays, images displayed on the screen for long periods of time may still appear after the screen content has been changed. This phenomenon can be corrected, over time, by switching display content or leaving the monitor off for a number of hours.

•If the screen becomes dark, flickers, or does not light-up, contact your dealer or the nearest service center for a backlight replacement. Do not attempt to replace it yourself.

Cleaning

WARNING

•If you dropped any material or liquid such as water onto the monitor when cleaning, unplug the power cable immediately and contact your dealer or the nearest service center. Always make sure your hands are dry when unplugging the power cable.

CAUTION

•For safety reasons, turn -off the power switch and unplug the monitor before cleaning.

•Do not scratch or rub the screen with a hard object.

•Never use any of the following solvents on the LCD Touch Monitor. Such harsh chemicals may cause damage to the cabinet and the touch sensor.

Thinner Spray-type cleaner, Benzene, Wax, Abrasive cleaner, Acid or Alkaline solvent

Cabinet

•Remove dirt with a lightly moistened cloth and a mild solvent detergent. Then wipe the cabinet with a soft dry cloth.

DISPLAY AREA (TOUCH SENSOR)

•Periodic cleaning with a soft dry cloth is recommended. Non-abrasive household window-type cleaners are recommended.

•Do not use tissue to clean the display area. It may scratch or dull the LCD screen.

Power Management

This LCD Touch Monitor complies with the VESA DPMS (version 1.0p) power management specification. DPMS provides four types of power saving modes by detecting the horizontal or vertical sync signal. As well, the computer graphic card also needs to be DPMS compliant to utilize these modes.

Item	DPMS Mode	Display	Power	Power		Recovery	H-sync	V-sync
			LED	Consumption		Time
1	On	Normal	Green	Normal		---	On	On
2	Stand By	No Display	Amber	捭	5 W	3 sec	< 10 KHz	On
3	Suspend	No Display	Amber	捭	5 W	3 sec	On	< 10 Hz
4	Off	No Display	Amber	捭	5 W	3 sec	< 10 KHz	< 10 Hz

9