PurepowerTM Series
3.Power Connector Introduction
PurepowerTM Series
4. Installation Steps
Cable
P/N Model
W0330 550W
W0329 450W
W0328 350W
|
|
|
|
|
|
20+4pin Main | 4pin +12V CPU | SATA | Peripheral | Floppy | 6pin |
Connector | Connector | Connector | Connector | Connector | Connector |
1 | 1 | 4 | 6 | 2 | 1 |
1 | 1 | 2 | 5 | 1 | 1 |
1 | 1 | 2 | 5 | 1 | 0 |
Note: Make sure that your system is turned off and unplugged. Disconnect the AC power cord from your old power supply.
1. | Open your computer case; please refer to the direction in your |
| case manual. |
2. | Install the PSU into the case with the four screws provided. |
3. | Connect the 24 pin Main Power Connector to your |
MODELS | Connector Type |
W0330 | 20+4pin |
W0329 |
|
W0328 | ATX 12V 4pin |
W0330 |
|
W0329 | Molex & FDD |
| |
W0328 |
|
W0330 | SATA |
W0329 |
|
W0328 | SATA | |
| ||
W0330 | ||
W0329 | ||
|
Connectors & Cable length
1x 24pin Main connector (400mm)
1 x ATX 12V 4pin connector
(400mm)
3 x Peripheral, 1 x FDD connectors (400mm + 150mm + 150mm + 150mm)
3 x Peripheral, 1 x FDD connectors
(400mm + 150mm + 150mm + 150mm)
3 x Peripheral, 1 x FDD connectors
(400mm + 150mm + 150mm + 150mm)
2 x Peripheral connectors
(400mm + 150mm)
3 x Peripheral connectors
(400mm + 150mm + 150mm)
2 x Peripheral, 1 x FDD connectors
(400mm + 150mm + 150mm)
2 x SATA connectors
(400mm +150mm)
2 x SATA connectors
(400mm +150mm)
2 x SATA connectors
(400mm + 150mm)
1 x 6pin
(400mm)
motherboard and peripheral. If your motherboard uses a |
connector, detach the
Note: The detachable
connector.
4.Connect the
5.Connect other peripheral power connectors to devices such as
hard drives, optical drives, etc.
6.Close your computer case and connect the AC power cord to the power supply AC inlet.
03 | 04 |