TR2 RX 700W ATX 12V 2.3 & EPS 12V 2.91 Version
3. Power Connector Introduction
Cable |
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
| |
| Main | ATX 12V | EPS 12V | SATA | Peripheral | FDD | CPU 4Pin | ||||
| Power | ||||||||||
| Connector | (4Pin) | (8Pin) | (8Pin) | (6Pin) | (5Pin) | (4Pin) | (4Pin) | 8Pin | to 4Pin | |
Model | to 6Pin | ||||||||||
(20+4Pin) |
|
|
|
|
|
|
|
| |||
W0366 | 1 | 1 | 1 | 1 | 2 | 6 | 6 | 1 | 1 | 1 | |
700W |
TR2 RX 700W ATX 12V 2.3 & EPS 12V 2.91 Version
4. Installation Steps
Note: Make sure that your system is turned off and unplugged. Disconnect
the AC power cord from your old power supply.
1. | Open your computer case; please refer to the direction in your |
| case manual. |
2. Install the PSU into the case with the four screws provided. | |
3. | Connect the 24 pin Main Power Connector to your |
| motherboard and peripheral. If your motherboard uses a 20- |
| pin connector, detach the |
| connector. |
| Note: The detachable |
MODEL
700W
Connector Type
20+4pin
EPS 12V 8 pin + ATX 12V 4pin
Molex & FDD
SATA
CPU 4pin to 4pin adapter
Connectors & Cable length
1 x 20+4pin Main connector
(500mm)
1 x EPS 12V 8 pin + ATX 12V 4pin connector
(500mm+150mm)
3 x Peripheral & 1 x FDD connectors
(500mm + 150mm + 150mm + 150mm)
3 x Peripheral connectors
(500mm + 150mm + 150mm)
3 x
(500mm + 150mm + 150mm)
3 x
(500mm + 150mm + 150mm)
1 x 8pin
(500mm)
2 x 6pin
(500mm+150mm)
1 x 8pin to 6pin adapter
(150mm)
1 x 4pin to 4pin adapter
(150mm)
a |
4.1 For motherboard that requires a single 4pin auxiliary (CPU) power connector, please use the 4pin ATX connector from the power supply.
4.2For motherboard that requires a single 8pin EPS connector, please use the 8pin EPS connector from the power supply.
5.Connect other peripheral power connectors to devices such as hard drives, optical drives, etc.
6.Close your computer case and connect the AC power cord to the power supply AC inlet.
03
04