Telenetics 202T, MIU202T manual Analog Line Specifications, Analog Line Type

Page 9

5. ANALOG LINE SPECIFICATIONS

The MIU202T contains analog circuitry for connection to the public conditioned or unconditioned, Bell type 3002, 2 or 4-wire, full duplex voice grade leased lines or metallic lines (eg; pilot wires). The MIU202T will also interface to Power Line Carrier or Microwave radio voice channel networks.

The MIU202T has an RJ-11terminated connector. The following lists the MIU202T analog interfaces

Analog Line Type:

Conditioned or unconditioned, Bell type 3002, 2 or 4-wire, full duplex voice grade or metallic lines or better.

Analog Line Specifications:

 

Bandwidth

300 Hz to 3400 Hz (±3dB)

Impedance

600 / 900 ohms , balanced

Frequency Response

400 to 3000Hz (±2dB)

Receiver Input Level

-16dBm max.

Output Level

+7 dBm

Noise Signal Level

-48 dBmO

MIU202T Installation, Operation & Diagnostics Edition: April 4, 1998

Page 7

Image 9
Contents MIU202T ARC Electronics Telenetics CorporationOutline Drawing & Mounting Table of ContentsStandards Product Overview General Product Specifications Modem Specifications Other Features Dip Switch Selectable ~ See SectionAnalog Line Specifications Analog Line SpecificationsAnalog Line Type Analog Microwave Interface Crosstalk unintelligible Adjacent channel Power Connections Serial Data Port PIN-OUTS OFF Wire RTS/CTS Delay TimeFor clarity, a blank space = OFF LED Indicator Outline Drawing & Mounting Test 2 Transmit Signal Power & Receive Levels DiagnosticsLocal Analog Loopback Figure Test 1 RTS/CTS Analog ControlLocal Digital Loopback 4/Wire Network Figure Test 3 Received Signal LevelConnect TxD to RxD at the remote modem Remote Digital Loopback 4/Wire Network FigureAdjustments… Line DiagnosticsPage Page