SOYO SY-K7ADA user manual Reset, Speaker, Ide Led

Hardware Installation SY-K7ADA

2.Reset

Plug the Reset push-button cable into the 2-pin Reset header on the Motherboard. Pushing the Reset button on the front panel will cause the system to restart the boot-up sequence.

Reset Pin Assignment

Pin1 Pin2

Power RST GND

3.Speaker

Attach the 4-pin PC speaker cable from the case to the Speaker header on

the Motherboard.

Speaker Pin Assignment

Pin17+Pin18 Pin19_Pin20

Power NC NC Speaker out

4.IDE LED

Attach the 2-pin IDE device LED cable to the corresponding IDE LED header on the Motherboard. This will cause the LED to light up when an IDE (HDD, CD-ROM) device is active.

HDD LED Pin Assignment

Pin9+ Pin10_

Power HDD LED

25