4.From Choose Destination Location window, click Next.
5.Remove the Driver Installation diskette, select Yes to restart Windows and click Finish.
To verify successful installation in Windows NT 4.0:
1.Go to Start / Setting / Control Panel, double click SIIG Cyber PCI 20X device icon.
2.New COM port address and LPT number will be assigned for the ports when successfully installed. The board is ready to connect devices.
Note If you plan to connect a parallel device other than a printer to the parallel port, such as zip drive, or scanner, please follow the next section to change the port's I/O address to support these devices.
To change the I/O address in Windows NT 4.0:
1.Double click Start, Settings, Control Panel, then SIIG Cyber PCI 20X device icon.
2.Highlight the LPT or COM address and click Settings.
3.Select or type in an I/O address supported by the device you would like to configure and click OK. Make sure the selected I/O address does not conflict with other device in your system.
4.Select Restart Now for the new setup to take effect.
Windows 2000:
1.At the New Hardware Wizard, click Next.
2.Select Search for a suitable driver for my device (recommended) and click Next.
3.Select Specify a location, uncheck the other options and click Next.
4.Insert the Driver Installation diskette, type in A:\Win2K and click OK.
5.Click Next and Finish to complete driver installation.
4