Printer 900 Installation Guide
Installing the Paper Roll
Refer to Figure 8 on the next page while performing these steps.
The Printer 900 accepts paper that is 76mm wide. There are three different types of roll paper available from VeriFone. These are listed in the Accessories Section on page 11.
Note: For best results, be sure the leading edge of the paper roll is cut cleanly rather than torn before feeding it into the printer. This is particularly important when insert- ing
1.Remove the roll cover by pressing the tabs on both sides of the paper cover and lifting the cover up.
2.Hold the paper roll at the front of the paper cavity, with the paper roll facing you, unrolling from the bottom. Slowly move the paper roll down and backwards, into the cavity, until the paper support arms snap into the paper roll core.
3.To engage the auto feed mechanism, take the end of the paper roll and gently guide the paper end into the paper feed path. The paper feed path is on the base of the paper cavity in front of the paper roll. The paper feed path is marked with an arrow. As soon as the sensor detects the paper, the printer will automatically feed and advance the paper.
4.Replace the roll cover onto the printer, sliding the front edge of the cover behind the tear bar. Make sure that the paper extends through the slot on top of the printer, and then snap the roll cover into place.
CAUTION: If you must remove the paper roll, do not pull the paper out from the back of the printer. This could damage the feed mechanism. Instead, cut or tear the pa- per from the rear of the printer. Use the paper feed but- ton to remove the stub remaining in the feed mechanism.
8