Vanguard Managed Solutions 650 652/654 With POTs and Battery Backup, Step Action

Page 22

652/654 POTS With/Without Battery Backup

652/654 With POTs and Battery Backup

Rechargeable

The 652 and 654 devices are also available with a 12 volt rechargeable battery

Battery Pack

backup pack. This pack consists of ten 1.2 volt NiCd battery cells in a metal carrier.

 

This enables these units to support POTS and ISDN operation during power failures,

 

for approximately 2.5 hours of normal telephone use. If both POTS ports are in

 

continuous use during battery operation, the useful time drops to approximately 1.5

 

hours. Battery operating time (capacity) is also dependent on the temperature;

 

battery capacity decreases as temperature increases.

Operation On

 

To reduce power consumption, during battery operation, the data and modem ports

Battery Backup

will not operate. When the battery is in operation, the power LED flashes.

 

The electric power plug, which connects to the external wall-mounted power supply,

 

acts as a battery switch. When the power supply transformer is plugged in, the

 

battery is connected to the circuit, and vice versa.

Recharging Battery A completely discharged battery pack takes about 14 to 16 hours to fully recharge.

PackThe charging circuit activates every time the unit powers up. After 16 hours of operation, the charging circuit reduces the current to the batteries to a trickle charge level to prevent overcharging.

Replacing

The batteries are shrink wrapped around a metal carrier, installed inside the unit on

Batteries

the Printed Circuit Board (PCB). A pair of wires connects the battery pack to a

 

connector on the PCB. The connector is keyed to prevent inserting the connector the

 

wrong way and reversing the order of the battery pack.

 

To replace the battery, perform the following steps:

 

 

 

 

Step

Action

 

 

 

 

1

Remove the unit’s cover.

 

 

 

 

2

Remove the battery connection from the PCB.

 

 

 

 

3

Remove the screws on the bottom of unit that hold the battery pack in

 

 

place.

 

 

 

 

4

Remove the battery pack.

 

 

 

 

5

Install a new battery pack by performing these steps in the reverse

 

 

order.

 

 

 

Battery Disposal Please contact the Rechargeable Battery Recycling Corporation (RBRC), at one of the following telephone numbers, for specific information on the safe disposal and/or recycling of rechargeable batteries.

•Individual Household Batteries:1-800-822-8837

•Retailers Disposal:1-770-984-0708

1-8

Getting Started

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Vanguard Managed Solutions Product Declarations and Regulatory Information Safety WarningsProprietary Material Internet InformationHazardous Voltage Pots ConnectionConnecting Ports Contents Appendix A. Specifications Overview About This ManualThis section Describes Vorsicht About This Manual Related Documentation Product Company/OrganizationPage Questions Customer InformationCustomer Comments AboutPage Customer Response Card Page Chapter Supported ConfigurationsWhat Is the 650? ProtocolsVanguard 650 Series Features Sample Network Topology Sample 650 Network TopologyExternal Designation Connector Type Internal CTP 651/653 Data Only652/654 Pots With/Without Battery Backup 652/654 With Pots Support Types Equipment Supported Pots Support Guidelines652/654 With POTs and Battery Backup Step ActionBackup With BatteryStoring Introduction 651/653 Hardware Components Hardware652/654 Hardware Components Detailed 650 Series Front Panel Front PanelSwitch Switch Name Open /Down Closed/Up Position Panel DIP Switches653/654 Front Series Rear Panel Connectors Detailed 650 Series Rear PanelSoftware StepSoftware Option Statistics Screen 1 Page Installing 650 Series Hardware Overview Step To Perform This Action See This ProcedureChecking Your Shipment Contents Introduction How to Choose a Site for the Vanguard Choosing a SiteCabling the 650 Series Series Back PanelIsdn Cable Cable ClearanceAir Circulation Data 1 and DataChanging Modem StrappingDiagnosing Start Powering Up the Vanguard 650 SeriesPowering Up Up FailuresRemoving the Top Cover and Front Panel Panel RemovalInstalling and Coldloading 650 Series Software IntroductionOperating Software and Option Images Boot PromBoot Prom Filename Description Image FilenameOperating Software Where to Get Operating SoftwareWhere to Get File FormatsSoftware Filename Description Vanguide Installing SoftwareHow To Application SetSoftware Coldloading 650 Series Operating SoftwareColdloading Step Action ResponseResponse Loading Software via Tftp Download Before You BeginDisabled Downloading Software Using the Software Loader Application ManagerLoader Software Loader WindowSoftware Loader Verification Dialog Box Vanguard Software Loader Error Message Box Downloading Configuration Memory Cmem Vanguard Configuration LoaderLoader Error MessageOverview How To UseVanguide Terminal Vanguide TerminalMain Menu 10. Control Port Main MenuLinking Software Images Using Software Builder Restoring CMEMs Selecting a Predesigned ConfigurationSaving To Use SeeSelecting a Predesigned Configurations Using the CTP RestoringAction Result Saving and Restoring Configurations Using KermitConfigurations Using Kermit ThenRestoring Configurations Using Kermit Step Action ResultSaving and Restoring Configurations Using Tftp Configurations Using TftpPerform a warm boot to activate New Cmem Specifications Overview Appendix aProduct Specifications Figure A-1. RJ11/RJ45 Connector Pin Numbering Connector PinoutsPin # Interface Signal NameData 1 and Data 2 Cable Descriptions ITU-TRJ45 Interface Signal Name DB25 Pin Pin # Pin # Modem Signal WireRJ45 to DB25 RJ45 Interface Signal Name DB25 Pin # Interface Signal Name Pin # Data 2 DB25Page Software License and Regulatory Information This Appendix Restricted Rights Legend Software License and Regulatory Information Introduction Product Declarations Regulatory Information Product Declarations and Regulatory InformationCE Marking Netherlands French DRGApproval Radio FrequencyProduct Declarations and Regulatory Information Safety Warnings Page Return Procedures Introduction For Locations ContactGuidelines for Factory RepairPackaging Equipment ReturnIndex Contiinued

650 specifications

Vanguard Managed Solutions 650 is a comprehensive financial management platform designed to streamline and enhance investment management for both individual and institutional investors. This innovative solution integrates advanced technology with a user-friendly interface, making it accessible to a wide range of users.

One of the standout features of the Vanguard Managed Solutions 650 is its seamless integration of data analytics. The platform employs sophisticated algorithms to analyze market trends and investment performance, providing users with real-time insights that can inform strategic decision-making. This analytical capability allows investors to assess risk, optimize portfolios, and identify emerging opportunities in the market.

Another key characteristic of the Vanguard Managed Solutions 650 is its customizable dashboards. Users can tailor their views to focus on specific investments, asset classes, or market indicators that are most relevant to their individual strategies. This personalization enhances user experience, ensuring that investors have quick access to the information they need to make informed choices.

The platform also emphasizes automation, allowing for the efficient management of recurring financial tasks. Automated rebalancing and tax-loss harvesting are just two examples of features designed to minimize manual intervention, increasing productivity while reducing the likelihood of human error. This level of automation can be particularly beneficial for users managing multiple accounts or investment strategies.

Security is paramount, and Vanguard Managed Solutions 650 employs state-of-the-art encryption technology to protect user data and financial transactions. This focus on cybersecurity helps build trust amongst users, ensuring their sensitive information remains safe in an increasingly digital financial landscape.

Furthermore, the Vanguard Managed Solutions 650 is designed with collaboration in mind. Financial advisors can easily share insights with their clients and provide tailored investment recommendations. This collaborative approach fosters transparency and facilitates better communication between advisors and their clients, thereby enhancing overall client satisfaction.

In conclusion, Vanguard Managed Solutions 650 stands out as a robust and versatile platform that combines advanced technology with user-centric design. Its features—ranging from data analytics to customization options and security measures—promote effective investment management. With a focus on automation and collaboration, Vanguard continues to redefine how investors interact with their financial portfolios, making it a valuable tool in today’s fast-paced investment landscape.
Top Page Image Contents