Parity | Enable Parity | |
Odd/Even | Odd, Even or No Parity can be selected . | |
RF Channel | On of 17 RF Frequency can be selected. | |
Key Transmitter | The transmitter carrier can be switched on. A distant modem can them use the RSSI bar | |
| graph to check the signal strength. | |
RSSI | Displays a Bar Graph of Relative Signal Strength. | |
Txmitter Speed | Sets the transmission speed: S = 5Kbps, F= 10Kbps | |
Address Mode | Enables Modem Address. This can be used in with the ATT Instruction to pass data to specific | |
| modems. | |
TX Address | Set Transmitter Address. | |
RX Address | Set Receiver Address. | |
RF Sensitivity | Sets the Receiver Sensitivity | |
Restore Defaults | Set Factory Defaults. | |
Exit without Save | Return to Modem | |
Advanced Menu |
|
|
Return to Main Menu | Display Main Menu by pressing the left Arrow Key | |
Enable AT Instructions | AT instruction are enabled. The modem will act on AT instruction present as the first | |
|
| set of characters in a data string. |
TX Priority |
| Data will be transmitted when RF noise is present at the receiver. |
Display Journal |
| Used for test diagnostics. |
Packetise Data |
| Data is formed into packets with error detections and Acknowledgments. When the |
|
| modem has received a full packet of data or at the end of a data string CTS is taken |
|
| low to suspend data from the host. |
Number of Retries |
| Sets number of retries |
Packet Size |
| Sets the number of bytes in the packet size. |
Logger Mode |
| Data will be stored in the modems memory until interrogated by a Distant Modem |
Enable Remote Access | Allows distant Modem to change settings. | |
Access Remote Modem | Displays settings of remote | |
Engage Rpt Path |
| Enables the data repeater path entered below. |
Set Repeater Path |
| Sets the Modem ID numbers of the required repeater path. |