Setup & Configuration
—Beep and Delay
The 'BeepVolume' configuration changes the volume of the audible indicator of the WLP 4170 CCD Scanner.
NOTE: For help in configuring these settings, consult the programming steps on page 5.
1. Scan “Begin ”
2. Scan “Set Beep Volume”
3.Pick a setting from the table at right, then turn to the back cover flap and scan the corresponding two digits. For example: if you desire no beep, scan 0 and 0 on the back cover flap
4.Scan the “Set” barcode on the back cover flap
5.Scan the “Exit” barcode
Begin
Set Beep Volume
Beep Volume Settings
00 | None |
01 | Lowest |
02 | Low |
03 | Medium (Default) |
04 | |
05 | High |
06 | |
07 | Highest |
Exit
7