Wasp Bar Code WLR8900 Series manual Quick Start

Page 7

Chapter 4

Quick Start

Your Wasp WLR8900/8905 Scanners are ready for use. The default settings of the scanners have been pre-programmed for the most common bar code configurations. Use the “WLR8900/8905 Setup & Configuration” sections only to customize the scanners settings. Please review the “Enable Barcode Symbologies” configuration beginning on page 14 to see the list of barcode symbologies which are enabled by default.

Tip:

•Use the pre-printed “Barcode Test Symbols” in Appendix A on pages 29-31 as a test chart to practice scanning.

PS2 Connection

USB Connection

5

Image 7

Contents Programming Guide CCD LR Programming Guide Table of Contents Introduction Barcode Symbologies Installation Quick Start Setup & Configuration Chapter Beep Settings Interblock Delay UPPER/LOWER Case Keyboard Language PREAMBLE/POSTAMBLE Configuration Terminator ENABLE/DISABLE Barcode Symbologies EnableENABLE/DISABLE Barcode Symbologies Code 39 Settings Interleaved 2 of 5 and Code 93 Settings Disable Code Code 128 and UCC/EAN 128 SettingsMSI Plessey Settings Codabar Settings UPC-A Settings UPC-A Supplement Settings UPC-E Settings UPC-E Supplement Settings EAN-8 Settings EAN-8 Supplement Settings EAN-13 Settings EAN-13 Supplement Settings Barcode Test Symbols Appendix a Appendix a Barcode Test Symbols EAN/JAN-13 Appendix B Appendix B Eps DEL Appendix C Function Code for PC Performance Technical Specifications Appendix DWarranty Information FAQ Product Support Wasp Barcode Technologies Wasp Barcode Technologies