1250/1750/2750 Manual 3/6/02 2:45 PM Page 29
OPERATION SUMMARY
•If the rated power consumption of the equipment is in the range of the maximum specified wattage of your converter, test the inverter to ensure that it will operate properly.
•Before attempting to use a battery charger see page 19.
•Before attempting to use medical equipment see page 8.
•Use the heaviest gauge wire (smaller the number, the larger or heavier the cable) available to connect the inverter to the power source.
•When operating the inverter with the engine off, start the engine every 30 to 60 minutes and let it run for at least 10 minutes to recharge the battery.
•In the event of automatic shut down, turn the inverter OFF (O) immediately. Do not restart the inverter until the source of the problem has been identified and correct- ed.
•To avoid battery drain always disconnect the inverter when the vehicle is not in use for long periods.
•Do not expose the inverter to moisture.
•Avoid placing the inverter near sources of heat or in direct sunlight.
26
OPERATION SUMMARY
•When in use, make certain that the inverter is proper- ly ventilated.
•Do not use the inverter near flammable materials, fumes, or gases.
•Always operate the inverter in accordance with the instructions in this manual. Failure to do so may result in property damage, personal injury, or loss of life.
•While connecting the inverter to the power source, make certain that the inverter is well removed from any potential source of flammable fumes or gases.
•Direct connection of the 2000 model inverter to a dis - tribution panel is to be made by a licensed electrician only.
•Always ground the inverter before operating it.
•In the event a continuous audible alarm or automatic shut off, turn the inverter OFF immediately. Do not restart the inverter until the source of the problem has been identified and corrected.
27