Clock Setup, Set & Forget Clock | Acu-Rite 19958, 19956 guide

SETUP

Clock Setup

Install or Replace Batteries

1Remove battery compartment cover.

2Insert 2 x AAA alkaline batteries into the battery compartment, as shown. Follow the polarity (+/-) diagram in the battery compartment.

3Replace the battery cover.

Set & Forget® Clock

Set & Forget® clock and calendar are pre-programmed to the correct time and date, and update automatically for Daylight Savings Time. All you need to do is select your time zone using the “TIME ZONE” dial.

Set the Time & Date

Choose the correct time zone (HAST AKST PST MST CST EST AST) using the “TIME ZONE” dial on the bottom of the clock in the battery compartment.

Choose Daylight Savings Time ON or OFF using the DST switch on the top of the clock. If you live in an area that observes Daylight Savings Time, DST should be set to ON, even if it is not currently Daylight Savings Time.

Press and release the “TIME SET” button to enter the SET MODE. Once in the SET MODE the preference you are currently in will blink on the clock.

To save your adjustments, press and release the “TIME SET” button to adjust the next preference. The preference order is as follows:

CALENDAR DATE

CALENDAR YEAR

TIME (Please note PM Indicator light)

You will not automatically exit SET MODE until “TIME SET” is pressed after adjusting the time. Enter SET MODE any time by pressing and releasing “TIME SET”.

PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.

BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove batteries from equipment which is not to be used for an extended period of time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of used batteries properly. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fire, as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals.