Settings of the Sound Characteristics

PIEGA P SUB 1 MKII

Setting options for individual requirements...

Thanks to the use of the most advanced active electronics, your new PIEGA P SUB 1 MKII is a cutting edge product in the field of subwoofers. Thanks to the variable „HP Filter Q“ it features the ability to simulate an unlimited range of sound characteristics. This enables you to adjust operation within the deep bass range to your individual audio requirements, as well as to those of the listening environment.

VOLUME

MIN.MAX.

0 180 PHASE-SWITCH

PHASE-SHIFT

ON OFF SUBSONIC

FILTER-Q

60Hz

CROSSOVER

FREQUENCY

40Hz 140Hz

VOLUME

>Use this knob to adjust the subwoofer volume

Setting tip: Turn the subwoofer to maximum volume and then turn it down until it sounds too quiet for you

PHASE-SWITCH

>Use this switch to set the subwoofer to In Phase or Out of Phase. Depending on the type of loudspeaker, there will be a phase cancelling (little bass) or a phase correction (normal bass)

>>Factory setting 0

PHASE-SHIFT

>Use this knob to adjust the phase to your system >>Factory setting 0

SUBSONIC

>Use this selector switch to activate the SUBSONIC filter. This is used to filter out frequencies below 15 Hz and thus relieve the subwoofer of inaudible frequencies

>>Factory setting OFF

FILTER-Q

>Use this knob to set the filter quality in the range between 0.5 to 0.8 - Turning the knob clockwise will cause a dry, clean and very precise bass, turning the knob anti-clockwise will produce a warm and more mellow bass

CROSSOVER-FREQUENCY

>This knob is used for adjusting the crossover frequency between subwoofer and full-range speaker

>>Factory setting 80 – 100 Hz