Panasonic CF-25 Computer Diagnosis, List of Error Codes, Using the Self-diagnosis Program

Computer Diagnosis

List of Error Codes

If a problem occurs with your hardware, and [POST Start up Error(s)] is displayed along with the error code(s), follow the on-screen instructions.

	S e t u p :	Setup Utility ( page 40) is started. Run [Load Default Settings (PnP)].
		Next, the Setup Utility must be run again to input the appropriate operating environ-
		ment settings.
	Exit :	Ignore the error message(s), and restart the computer.
C o d e			D e s c r i p t i o n
062	Boot failure--default configuration used		Default configuration in use
101	System Board Failure		Interrupt controller failure
102	System Board Failure		Timer 2 test failure
106	System Board Failure		Diskette controller failure
114	Adapter ROM Error		Adapter ROM checksum error
151	System Board Failure		Real-time clock failure
161	Bad CMOS Battery		Dead battery
162	Configuration Change Has Occurred		Configuration error
162	Configuration Error		CMOS checksum error
163	Date and Time Incorrect		Real-time clock is not updating
164	Memory Size Error		Memory size error
201	Memory Size Error		Memory size/data error
301	Keyboard Error		Keyboard failure
303	Keyboard Error		Keyboard controller failure
662	Configuration Change Has Occurred		Diskette drive 0 configuration error
762	Configuration Change Has Occurred		Coprocessor configuration error
962	Configuration Change Has Occurred		Parallel port configuration error
1162	Configuration Change Has Occurred		Serial port configuration error
1762	Configuration Change Has Occurred		Fixed disk configuration error
1780	Hard Disk Error		Fixed disk 0 failure
1800	PCI Error		No more IRQs available
1801	PCI Error		No more room for optional ROM
1802	PCI Error		No more I/O space available
1803	PCI Error		No more memory (above 1 MB) available
1804	PCI Error		No more memory (below 1 MB) available
1805	PCI Error		Checksum error or 0 size optional ROM
1806	PCI Error		PCI-PCI bridge error
1962	IPL Error		An operating system could not be found
I9990301	IPL Error		Hard disk failure
I9990305	IPL Error		An operating system could not be found

Using the Self-diagnosis Program

Follow the procedure below to check whether each part of your computer is operating properly.

1 To run the program, insert the Firstaid FD you created into the floppy disk drive, then turn your computer on

2

3

When the display below is shown, select [1. Boot]

1.Boot

2.Restore HDD to factory default (For beginners)

3.Restore HDD to factory default (For advanced users)

At the MS-DOS prompt (A:\WINDOWS\COMMAND>), input the following:

diag25

Follow the messages on the screen.

2 9