Fujitsu GBR-222200-002 Communication, Is disconnected, Soon after, Connection to, Access point

Osian_UG.book Page 59 Monday, October 9, 2006 1:24 PM

				W i r e l e s s L A N U s e r ’ s G u i d e
Problem	Possible Cause			Possible Solution
Unavailable	It takes too long to	Retrieve computers as follow:
network	retrieve the network	1. Click [Start] button, then click [Search].
connection	and display the
		2. Click [Computers or people].
(continued)	connected
	computers.	3. Click [Computers on the network].
		4. Input the name of computer to be connected with in [Computer
			name] and click [Search].
		5. Double-click the icon of connected computer.·
	Incorrect setting of IP	Check the network setting.
	address	“Setting the network” on page 53.
		In case of using TCP/IP protocol, you can check IP address as follows:
		1.	Click [Start] -> [All programs] -> [Accessories] ->
			[Command prompt].·
		2. In [Command prompt] or [MS-DOS prompt] window, input
			[IPCONFIG] command as follows, then press [Enter] key.
			Example: In case of C drive being the hard disk:
			C:\ipconfig [Enter]
			Check that the IP address is correctly displayed:.
			IP Address................: 10.0.1.3
			Subnet Mask.............: 255.255.255.0
			Default Gateway.........: 10.0.1.1
			When IP address is displayed as [169.254.XXX.YYY] or [0.0.0.0],
			IP address is not correctly fetched from the access point. In that
			case, restart the computer itself. If the display is still unchanged,
			check the setting of TCP/IP.
			If [Cable Disconnected] or [Media Disconnected] is displayed
			without showing IP address, check the setting of network name
			(SSID) and network key. Also, set the network authentication
			according to the access point.
Communication	Access control may	Check the setting of “Enable network access control using IEEE
is disconnected	be disabled	802.1X”.Refer to “Assigning parameters” on page 51.
soon after		When restricting the access of wireless LAN clients using IEEE802.1X
connection to		authentication, put a check mark on “Enable network access control
the access point		using IEEE 802.1X”.
		When using at home, remove a check mark on “Enable network access
		control using IEEE802.1X”.
		For the method of setting related with IEEE802.1X authentication, refer
		to the access point manual.
	Authentication	Re-enter your WEP key and verify that your authentication method
	method may have	(Open or Shared) is correct.
	been entered
	incorrectly

59