Horizontal Array Bracket Installation Instructions
Horizontal array brackets are used to mount two Control loudspeakers to a wall (Figure 1) or, when combined with two additional brackets, six loudspeakers may be attached then suspended from a ceiling or beam (Figures
The loudspeaker’s left and right side tapers allow two speakers to array in a horizontal arc pattern for a wide coverage in the horizontal plane. Aiming angles can be adjusted via the speaker’s Invisiball™ adjustment system for fle xibility in meeting coverage requirements.
Caution: this bracket should be installed by a qualified technician only.
Use the diagrams on the following pages to properly install this wall mounting and ceiling suspended bracket and loudspeakers. The following items are included in the
1. | 1 pc. Mounting Bracket | 5. | 4 pcs. |
2. | 8 pcs. Screws ¼ | 6. | 4 pcs. # 10 flat washer |
3. | 8 pcs. Flat washer (¼ " inside) | 7. | 4 pcs. # 10 1ock nut |
4.8 pcs. Locknut (¼
Wall Mounting
Step 1.
Install The two Invisiballs onto the bracket (see figure 1) using the included screws (item #2).washers (item #3) and lock nuts (item #4). Be sure that all screws and lock nuts are tightened for a Permanent Installation.
Step 2.
Secure the bracket assembly to the mounting surface.
Caution: Always be sure the mounting surface and the method of attaching the bracket to the mounting surface is structurally capable of supporting the weight of the speakers and the brackets with a 10:1 safety ratio. If you have any doubts of the capability, do not install this bracket.
Step 3.
Follow instructions included with the Control 28 loudspeakers for mounting the speakers onto the Invisiball™ mounting bases and for adjusting the aiming angles.
3