QUAD Speaker Home Theatre Loudspeaker Connections, Getting the Best from Your Loudspeakers

Page 3

HOME THEATRE LOUDSPEAKER CONNECTIONS

HF

L-ite Centre

Centre

Front Right

LF

Front Left

HF

Centre

Front Right

 

LF

 

Rear Right

 

A/V

Amplifier

HF

Front Left

LF

Rear Left

HF

Right

 

LF

Surround

 

Subwoofer

INPUT

OUTPUT

LEFT RIGHT

LINE LEVEL

QUAD L-ite Subwoofer

Left

HF

 

Surround

LF

 

SETTING LOUDSPEAKER SIZES IN HOME THEATRE SYSTEMS

Many digital AV Processors require you to specify the size of speakers in all channels.

These are usually ‘Large’ or ‘Small’.

Always choose 'Small' for the Surround channels and Centre channel whether you are using a subwoofer or not.

If you are not using a subwoofer: Set the Front Speakers to ‘Large’. Set the ‘Subwoofer’ option on the processor to ‘Off ’ or ‘No’. The Front channels will receive all the system bass.

If you are using a subwoofer: When set to ‘Small’ all the system bass will go into the subwoofer. If you choose ‘Large’ the Front channel bass will be sent to the Front speakers. Bookshelf speakers should be set to ‘Small’, large floor standing units may be set to ‘Large’.

Refer to your A/V processor manual for details on setting up your Home Theatre system.

GETTING THE BEST FROM YOUR LOUDSPEAKERS

Phase

If the sound lacks definition or the bass is indistinct, this could be because you have inadvertently mis-connected your loudspeakers. Please check the wiring to all the loudspeakers carefully, especially if they are bi-wired.

Ancillary Equipment

QUAD loudspeakers are compatible with the great majority of audio-visual and high fidelity equipment - but a loudspeaker is only as good as the signal it gets. Your amplifier should have ample reserves of power - a low powered amplifier can run out of steam and the resulting distortion is unpleasant to listen to and could damage your speakers. A larger amplifier will usually sound better and enhance the reliability and performance of your loudspeakers.

Running In

Loudspeakers are electro-mechanical and, like all mechanical systems, they need a 'running in' period. For the first 50 hours or so exercise care and play your system at reasonable volume levels. After running in, you will notice a significant sonic improvement.

Care and Maintenance

Little maintenance is required. The cabinets can be occasionally wiped with a damp (not wet) cloth. Spray polish, if used, should be applied sparingly - spray the polish onto a cloth and then apply it to the speaker. NEVER spray the grille cloth or the speaker drive units. To clean the grilles, remove them first before gently brushing with a soft brush. Never use solvent cleaners, minor stains are best removed with soap and lukewarm water.

INTRODUCTION

The Quad L-ite Centre is a dedicated centre channel loudspeaker, voiced to blend seamlessly with the other loudspeakers in the L-ite Series, though it can be used with any high performance loudspeakers.

A secondary use could be as low level background sound reinforcement applications where clarity and precision are a requirement.

When partnered with either a pair of Quad L Series loudspeakers as the Front channels, and the Quad L-ite Satellites as Rear Effects channels, a Home Theatre system of outstanding performance can be built up.

Please read the following notes carefully. They will help you to install your

loudspeaker correctly and safely.

!Switch off the amplifier and all sources before making connections to your sound system. When you switch on the system or change sources, set the volume control to minimum and turn up the level gradually.

!The position of your Volume Control is NOT a reliable guide as to the maximum capabilities of your sound system. Playing the system with extreme settings of volume and/or tone controls may damage the amplifier and loudspeaker and your hearing.

!Do not connect loudspeaker terminals to the mains supply.

!Ensure that your loudspeakers are correctly wired and are in phase.

!Do not subject your loudspeakers to excessive cold, heat or sunlight.

!WARNING: To reduce the risk of fire or electrical shock do not expose this product to rain or moisture. The product must not be exposed to dripping and splashing and no object filled with liquids - such as a vase of flowers - should be placed on the product.

!No naked flame sources - such as candles - must be placed on the product.

!Do not place heavy objects on top of loudspeaker cabinets. If you play the loudspeakers with the grilles removed be careful to protect the drive units from children and pets.

!Do not use makeshift stands. Always fit a manufacturer's approved stand using the instructions and the fixings provided. Your dealer will advise you.

!Do not attempt to dismantle the loudspeaker. There are no user serviceable parts inside and you will invalidate the warranty.

!The Centre Channel loudspeaker is screened and may safely be operated close to a TV set.

4

 

1

Image 3
Contents Ite Centre Ohms 100mm25mm Dome 30 150 WIntroduction Setting Loudspeaker Sizes in Home Theatre SystemsHome Theatre Loudspeaker Connections Getting the Best from Your LoudspeakersPositioning Your Loudspeakers Connecting the LoudspeakerConnecting Speaker Terminals Unpacking the Equipment