Nortel Networks 8672ATMM manual Connecting ﬁber cables

Page 32

32Media Dependent Adapter installation for the 8672ATME and 8672ATMM modules

5If you do not plan to install a replacement MDA, place the slot cover on the MDA slot and tighten the two screws.

--End--

Connecting ﬁber cables

This procedure describes how to connect fiber cables to the installed MDA. The OC-12c/STM-4 MDA uses duplex SC connectors. See Figure 5 "OC-12c/STM-4 MDA duplex SC connector with dust caps" (page 32). Also, the OC-3c/STM-1 MDA uses MT-RJ connectors. See Figure 6 "OC-3cMDA/STM-1MT-RJ connector with dust cap" (page 32).

Figure 5

OC-12c/STM-4 MDA duplex SC connector with dust caps

Figure 6

OC-3c MDA/STM-1 MT-RJ connector with dust cap

Procedure steps

Step Action

1Remove the protective dust plug from the connector on the installed MDA. Store the dust plug for later use.

Nortel Ethernet Routing Switch 8600

Installation — Media Dependent Adapters for the 8672ATME and 8672ATMM Modules

NN46205-316 01.01 Standard

30 May 2008

Copyright © 2008 Nortel Networks

Image 32

Contents NN46205-316 Legal Notice Contents Copyright 2008 Nortel Networks FCC Statement USA only Regulatory Information and Safety PrecautionsInternational Regulatory Statements of Conformity CE Marking Statement Europe only EN 55 022 Statements EN 55 024 StatementEN 300386 Statement EC Declaration of ConformityVcci Statement Japan/Nippon only Bsmi Statement for 8010, 8006 and 8003 Chassis Taiwan onlyNOM Statement 8010, 8006, and 8003 Chassis Mexico only National Safety Statements of ComplianceCE Marking Statement Europe only EN 60 950 Statement National Safety Statements of Compliance Información NOM unicamente para MéxicoDenan Statement Japan/Nippon only Safety Messages ESDAttenzione ESD Avertissement Peligro Pericolo Regulatory Information and Safety Precautions Software license Nortel Networks Inc. software license agreementGeneral Nortel Networks Inc. software license agreement Software license Features New in this releaseOther changes Document changesNew in this release Introduction NavigationIntroduction MDA overview DS-3 MDA 8672ATME and 8672ATMM modules Prerequisites Estimated installation timeEstimated time for installation Installing an MDA Task and estimated time cont’d Estimated timeInstalling an MDA End Replacing an MDA Connecting ﬁber cables Connecting fiber cables Connecting coaxial cables Push the coaxial cable onto the DS-3 connectorConnecting coaxial cables Copyright 2008 Nortel Networks Translation of Safety messages Class a product caution statementESD Cuidado ESD Translation of Safety messages Appendix MDA and LED speciﬁcations MDA speciﬁcationsLEDs MDA LED indications Label Color State Meaning MDA and LED specifications Page Nortel Ethernet Routing Switch