Panasonic CQ-RG131W manual Installation Guide, Preparation

Page 13

Installation Guide

Preparation

Before installation, check the radio operation with antenna and speakers.

Disconnect the cable from the negative (–) battery terminal (see caution below).

Unit should be installed in a horizontal position with the front end up at a convenient angle, but not more than 30°.

E

N

G

L

I

S

H

10

Caution:

For installation to cars with trip or navigational computers, all electronic memory settings previously registered in the computer will be lost when the battery terminal is disconnected. For this type of car, battery could not be disconnected. Therefore, extra care should be taken to prevent short circuitting.

In-dash Installation

Installation Opening

In-dash installation can be done if the car’s dashboard has an opening for this unit as shown in Fig. 1. The car’s dashboard should have a thickness of 4.5 mm - 6 mm in order to make the installation of the unit.

Installation Precautions

53 mm

182 mm

Fig. 1

This equipment, if possible, should be installed by a professional installer.

In case of difficulty, please consult your nearest authorized Panasonic Service Center.

1.This system is to be used only in a 12-volt, DC battery system (car) with negative ground.

2.Follow the electrical connection on page 18 carefully. Failure to do so may result in damage to the unit.

3.Connect the power lead after other connections are made.

4.Be sure to connect the YELLOW lead to the positive terminal (+) of the battery or fuse block (BAT) terminal.

5.Insulate all exposed wires to prevent short circuitting.

6.Secure all loose wires after installing the unit.

7.Please carefully read the operating and installation instructions of the respective equipment before connecting it to this unit.

Supplied Hardwares

No.

Item

Diagram Qty

Mounting Collar

1

Hex. Nut (5 mm φ )

1

Rear Support Strap

1

Tapping Screw

1

(5 mm φ

x 16 mm)

 

No.

Item

Diagram Qty

 

Mounting Bolt (5 mm φ )

1

 

Power Connector

1

 

Dismounting Plate

1

 

Removable Face

1

 

Plate Case

 

 

13

CQ-RG131W

Image 13
Contents Operating Instructions Precautions ContentsCQ-RG131W Power Power and Sound ControlsVolume MuteBass and Treble Changing Audio ModesBalance FaderRadio Basics Manual Station Preset Preset Station SettingTuning in a Preset Station Auto Preset MemoryLoading a Cassette Cassette Tape Player BasicsRewind and Fast Forward Changing SidesStopping and Ejecting the Tape CD Changer Basics To Changer modeSelecting a Disc Selecting a TrackRepeating a Track Searching a TrackRandom Selection Scanning TracksResetting the Time Initial Time SettingSelecting the Clock Display Preparation Installation GuideInstallation Guide To Remove the Unit To Remove the Removable Face Plate Anti-Theft SystemTo install the Removable Face Plate CX-DP88N Electrical ConnectionRight Speaker ConnectionsTroubleshooting Tips TroubleshootingSpecifications MaintenanceFuse PWR SEL Mono Band Loud Eject Track Track Track AC K Track Disp BAT Mmφ CQ-RG131W Loud CQ-RG131W PRG CQ-RG131W Loud CX-DP88N Panasonic Btcl CDC Wrms Central P.O. Box 288, Osaka 542-8588, Japan