MICROBOARDS TECHNOLOGY, LLC | GX AUTO PRINTER |
Ink Tab
The Ink Levels show how much remains of all 3 colors, Cyan, Magenta and Yellow.
NOTE: If you place a used cartridge in the GX Auto Printer, the ink level may not be reported correctly. If the GX Auto Printer can identify the cartridge, it may report the correct ink levels; if not, it will assume that the ink cartridge is new and will show ink levels of 100%.
Before each disc is printed, the ink levels are checked. If the level of any one color is has reached 10%, a warning message will be displayed on your PC and printing will be temporarily suspended. You can either change the cartridge at this point and click OK, or click OK to continue printing using the same cartridge.
If you continue with the same cartridge, printing will continue uninterrupted until the ink level reaches 5%. The low ink level warning will be displayed once more. Again, either change the cartridge or continue.
Once the ink level reaches 3% or less, the warning will be displayed before each print.
It is strongly recommended that you replace the cartridge at this point.
The Ink Cartridge information includes the
Alignment Tab
Alignment values will move the print image on the disc. Use the graphic on the right side of the tab as a guideline in how alignment values should be adjusted.
The Resolution setting should always be set at .1mm for best results.
The Outer and Inner Diameters will change the size of the area to be printed. To avoid excessive ink buildup, these values should never be set so that the GX Auto Printer is printing off the media.
The default diameter settings are 1180 for the Outer and 360 for the Inner when the resolution is at .1mm. For
About Tab
The About tab provides you with contact information for the worldwide Microboards offices.
15