DR300 Quick Guide | Pg 22 |
| DR300 Quick Guide | Pg 11 | |
|
|
|
|
| |
Print image shifts from its position |
|
| • To open thermal head, turn head lock lever in the direction of the arrow. | ||
|
|
|
|
|
|
| Check Point | Remedy |
|
|
|
1. | Are the labels, carbon ribbons | Check if labels, carbon ribbons are fixed |
|
|
|
| properly set? | firmly and at the correct position by lifting |
|
|
|
|
| head assembly. |
|
|
|
2. | Is the platen roller dirty? | Clean dirt off from platen roller with cleaning |
|
|
|
|
| kit. |
|
|
|
3. | Are deformed labels, carbon | Use genuine SATO new labels, carbon |
|
|
|
| ribbons being used? | ribbons which are in good condition. |
|
|
|
4. | Are genuine labels, carbon ribbons | Genuine labels, carbon ribbons exclusively |
|
|
|
| exclusively for this equipment | for this equipment must be used. Available |
|
|
|
| being used? | from SATO. |
|
|
|
5. | Is the content of data, signal from |
|
|
| |
| the computer correct? | If similar message is displayed, check |
|
|
|
|
| content of software and communication |
|
|
|
|
| settings at the computer side. |
|
|
|
6. | Is the print position offset setting | Adjust the print position. |
|
|
|
| correct? |
|
|
|
|
|
|
|
| • Pass paper underneath the pitch sensor and paper guide shaft. |
|
|
|
|
| • Lightly push the entire paper against the paper guide designated position as shown in | |
|
|
|
| the picture below. |
|
•Disconnect printer from mains before cleaning.
•Adjust the sliding guide until it touches the label.