Dell HYPERV R1, R2 REV0.01 manual ∙ Do a Right-click. Choose Settings  Integration Services

Dell UPS Local Node Manager

USER'S GUIDE EXTENSION FOR MICROSOFT VIRTUAL ARCHITECTURES

Dellups.com

2.2. MICROSOFT HYPER-V MANAGER / HYPER-V SERVER R1 & R2 CONFIGURATION

For the automatic OS boot on start-up, the user must configure the physical machine to allow automatic OS boot on start-up. This is found in the machine’s BIOS.

For further information, see specific documentation of the physical hardware.

Note: It may be required to activate Virtualization Technology Enabled (in the machine’s BIOS) to run Hyper-V, in CPU Information -> Virtualization Technology -> Enabled

To enable graceful virtual machines shutdown, it is necessary to install on each Virtual Machine the additional program “Guest Component Service” included in the operating system and to configure it.

2.2.1.“GUEST COMPONENT SERVICE” INSTALLATION

∙Open the Hyper-V console and start your virtual machine.

∙Select the Action tab  insert the disk integration services.

∙Install the Service. To check that installation works fine, verify that the software is available in the Control Panel of the virtual machine ("Add / Remove Programs").

2.2.2.SERVICES CONFIGURATION

∙Open Hyper-V console and select the virtual machine where the service was installed.

∙Do a Right-click. Choose Settings  Integration Services.

∙Check the box "Operating System shutdown".

CHAPTER: Installation

Dell ULNM - User guide extension - HyperV R1 & R2	5
rev0.01