Dell J728N, K803N, H950N, H967N manual Safety Warnings, UPS Output Power

Page 9

2

Safety Warnings

CAUTION: Before performing the procedures in this document, read and follow the safety instructions and important regulatory information in your Safety, Environmental, and Regulatory Information document.

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS

This manual contains important instructions that you should follow during installation and maintenance of the UPS and batteries. Please read all instructions before operating the equipment and save this manual for future reference.

DANGER: Observe the following instruction to help prevent an imminently hazardous situation which, if not avoided, will result in death or serious injury:

SThis UPS contains LETHAL VOLTAGES. All repairs and service should be performed by AUTHORIZED SERVICE PERSONNEL ONLY. There are NO USER SERVICEABLE PARTS inside the UPS.

WARNING: Observe the following instructions to help prevent a potentially hazardous situation which, if not avoided, could result in death or injury:

S This UPS contains its own energy source (batteries). The output receptacles may carry live voltage even when the UPS is not connected to an AC supply.

S Do not remove or unplug the input cord when the UPS is turned on. This removes the safety ground from the UPS and the equipment connected to the UPS.

S To reduce the risk of fire, connect only to a circuit provided with branch circuit overcurrent protection with an ampere rating in accordance with the National Electrical Code® (NEC®), ANSI/NFPA 70 or your local electrical code:

UPS Output Power

120V

208V

230V

 

 

 

 

2700W

30A

20A

16A

 

 

 

 

S To reduce the risk of fire or electric shock, install this UPS in a temperature and humidity controlled, indoor environment, free of conductive contaminants. Ambient temperature must not exceed 40°C (104°F). Do not operate near water or excessive humidity (95% maximum).

S Unpacking the cabinet in a low-temperature environment may cause condensation to occur in and on the cabinet. Do not install the cabinet until the inside and outside of the cabinet are absolutely dry (hazard of electric shock).

S If the UPS requires any type of transportation, disconnect the internal UPS batteries before transporting (see page 58).

Safety Warnings

9

Image 9
Contents Users Guide September 2009 S 164201788 Table of Contents Dell UPS Management Software RS-232 and USB Communication PortsUPS Status Menu Event Log Menu Testing BatteriesDell Online Rack UPS IntroductionIntroduction What are You Looking For? Find It Here Finding InformationUPS Output Power Safety WarningsSafety Warnings Do not add weight to slide/rail mounted equipment Inspecting the Equipment InstallationUnpacking the Cabinet Unpacking the CabinetLifting the Cabinet 120V Rear Panel Identifying the UPS Rear Panels230V Rear Panel Identifying the UPS Front PanelOpening the Metal Battery Cover Rackmount SetupIf installing additional UPSs, repeat for each cabinet Positioning the Rails Attaching the Rails to the Rack Installing and Securing the Cabinet Installing the Battery Tray Install the UPS front cover see Figure Removing the Battery Connector Cover Installing the EBMInstalling the Strain Relief Bracket EBM Installation Installing the UPSRepo Connections Wire Function Installing Remote Emergency Power-offRepo Connector Minimum Upstream Circuit Breaker Rating UPS Output Power Power Cord RatingsUPS Initial Startup Installation Operation UPS Startup and ShutdownStarting the UPS UPS Shutdown Starting the UPS on BatteryControl Button Functions Control Button Sequence Control Panel FunctionsChanging the Language Display FunctionsStartup Screen UPS Status Screen LockedBypass Mode Battery ModeBad Battery Detected or Battery Disconnected UPS General Alarms ActiveNormal Mode Status Summary Screens Description Battery Test StatusHigh Efficiency Mode Converter ModeEvent Log Battery Status Screens DescriptionMeasurements Control Screens Description Control ScreensSettings Settings Description Available Settings Default SettingIdentification Settings Description Available Settings Default Setting Settings Description Available Settings Default Setting Settings Description Available Settings Default Setting Settings Description Available Settings Default Setting Transferring the UPS Between Modes Transferring from Normal to Bypass ModeTransferring from Bypass to Normal Mode Setting Power StrategyBehavior on Overload Retrieving the Event LogControlling Load Segments Through the Display Configuring Load SegmentsConfiguring Automatic Start Delay Configuring Automatic on Battery Shutdown Configuring the UPS for an EBM Configuring Battery SettingsConfiguring Automatic Restart Running Automatic Battery TestsConfiguring Automatic Battery Tests RS-232 and USB Communication Ports Additional UPS FeaturesGND RS-232 Communication Port Pin AssignmentDell Network Management Card Dell Network Management Card OptionalDell UPS Management Software UPS Maintenance UPS and Battery CareTransporting the UPS Remove the UPS front cover see Figure Disconnect the internal battery connectors see Figure Storing the UPS and Batteries When to Replace BatteriesUpdating the UPS Firmware Testing BatteriesSpecifications Rated at nominal inputs Regulation Normal mode Power LevelsRegulation Battery mode Environmental and SafetyBattery Runtimes Battery ConfigurationVoltage FusesTroubleshooting Accessing Alarms and ConditionsUPS Status Menu Event Log Menu Typical Alarms and ConditionsAction Troubleshooting Troubleshooting Silencing the Alarm

J728N, K803N, H950N, H967N specifications

Dell has established itself as a leader in the technology sector, consistently delivering innovative products that cater to various user needs. Among its extensive lineup, models like the Dell H967N, H950N, K803N, and J728N stand out due to their distinctive features, technologies, and characteristics.

The Dell H967N is designed for versatility and performance, featuring robust hardware that supports demanding tasks. This model is equipped with a powerful processor, ensuring smooth multitasking and efficient handling of resource-intensive applications. Its advanced cooling technology is particularly noteworthy, preventing overheating during prolonged use. Additionally, the H967N boasts impressive graphics capabilities, making it suitable for both professional and recreational activities, such as graphic design and gaming.

Next in line is the Dell H950N, which emphasizes connectivity and efficiency. This model includes a variety of ports, accommodating multiple peripherals and external displays. Its integrated wireless technology provides seamless internet access and excellent data transfer speeds. The H950N also prioritizes energy efficiency, featuring a power-saving mode that helps reduce overall energy consumption without sacrificing performance.

The K803N model is focused on user experience, equipped with a high-resolution display that delivers vibrant colors and sharp images. This makes it ideal for content creators and media consumers alike. The K803N’s sound technology also deserves mention, featuring enhanced audio output that creates an immersive listening experience. Moreover, its ergonomic design ensures comfort during extended use, catering to users' needs for productivity.

Lastly, the Dell J728N is engineered for portability without compromising on performance. This lightweight model is easy to carry, making it a favorite among professionals on the go. The J728N features a long-lasting battery life, allowing users to work for extended periods without needing to recharge. Its sleek design and modern aesthetics enhance its appeal, while its solid-state drive technology ensures quick boot times and fast data access.

In conclusion, the Dell H967N, H950N, K803N, and J728N represent the brand’s commitment to quality and innovation. Each model brings unique features to the table, catering to diverse user requirements, whether it be performance, connectivity, user experience, or portability. Dell continues to lead the way in technological advancements, ensuring that its products remain relevant and highly sought after in the market.