Connecting Battery Packs

The PowerEdge Battery Backup Module usually is shipped with an onboard four-cell Nickel- Metal Hydride battery pack already installed. If this is the case, you must only insert the battery connector into J2, as shown below. The battery cable connector is keyed to make sure that the proper connection is made.

American Megatrends, Inc. P/N: BAT-NIMH-4.8.01

CAUTION

Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the

manufacturer. Dispose of used batteries according to the manufacturer's instructions.

ATTENTION

Il y a danger d'explosion s'il y a remplacement incorrect de la batterie. Remplacer uniquement avec une batterie du meme] type ou d'un type equivalent recommande par le constructeur.

Mettre au rebut les batteries usagees conformement aux instructions du fabricant.

WARNING

BEFORE ADDING OR REMOVING DRAM MODULE, DISCONNECT BATTERY PACK FROM BATTERY BACKUP MODULE.

PROMARK YYWW IIZ9503MSO

Attach battery pack connector to J2

Install PowerEdge Card Install the PowerEdge card in the computer. See the Dell PowerEdge RAID Controller User’s Guide for complete installation instructions.

Chapter 1 Installing the Battery Pack