Chapter 2 Installation and Maintenance
Only trained service personnel should install and maintain the Power Supply.
Prior to installing the enclosure AC line voltage must be routed to the installation site. Local, state, federal and/or National Electric Code (NEC) regulations regarding location, permits and electrical wiring must be adhered to.
Do not operate the Power Supply where the temperature and humidity are outside the specified limits. See Specifications in this manual.
Models Supported
CTEG4M | Encl, TSP (2), 4 | Batteries, Generator Control Module |
|
|
|
CTEG4M8M | Encl, TSP (1), 8 | Batteries, Generator Interface |
|
| |
CTEG4M12B | Encl, 12 Batteries | |
|
|
|
Unpacking
Inspect the unit upon receipt. Notify the carrier if there is damage. The packaging is recyclable; save it for reuse or dispose of it properly.
Check the package contents. The package contains the enclosure, battery cables, associated hardware, and product documentation.
CTEG4M: (9 cables) | 15” black battery jumpers (3), 28” black (1), 48” black (1), | |
|
| 15” red (1), 29” red (2), 30” red (1) |
|
|
|
CTEG4M8M: | (12 cables) | 15” black battery jumpers (4), 26” black (1), 27” black (1), 28” black |
|
| (1), 56” black (1), 15” red (1), 25” red (1), 34” red (1), 35” red (1) |
|
|
|
CTEG4M12B: | (17 cables) | 15” black battery jumpers (9), 30” black (2), 80” black (1), |
|
| 18” red (1), 30” red (2), 45” red (2) |
|
| |
CTEG4M when wired with | 15” black battery jumpers (3), 28” black (1), 48” black (1), | |
the CTEG12B: (8 cables) | 19” red (1), 29” red, 45” red (1) | |
|
|
|
3