American Power Conversion AP9215 user manual Status Display

Status

νStatus Display 1

￿Input Line Voltage and Frequency

￿Output Voltage

￿Runtime Estimate

￿Load (in Amps and % of VA capacity)

νStatus Display 2

￿UPS internal temperature

￿Last Transfer: the cause of the most recent on-battery event.

None -	the UPS has not been on battery recently.
Test -	a self-test caused the UPS to briefly run on
	battery.
Notch/Spike -	AC line voltage was non-sinusoidal or se-
	verely distorted; includes total power failure.
Low Voltage -	AC line voltage went below the lower transfer
	point. The lower transfer point is user adjust-
	able in certain UPS models, see
	Setup:Transfer menu.
Hi Voltage -	AC line voltage exceeded the upper transfer
	point. The upper transfer point is user adjust-
	able in certain UPS models, see
	Setup:Transfer menu.
Rate of Chng -	abrupt change in line voltage
CirBrkr Trip -	input circuit breaker tripped (Symmetra
	only)

￿Status: a terse indication of the state of the UPS. The most common are On-Line (AC line quality is acceptable), UPS/ Load off, On-battery (load is powered from battery), Low- Battery (battery is fully discharged), Overload, or any one of a number of internal faults. Use Diagnostics from the top level menu for a detail of the UPS status and faults.

￿Number of installed batteries and bad batteries (Matrix-UPS and Symmetra only)

8