APC CTFRP Installation and Maintenance, Installing the Power Supply, Enclosure Installation

Page 5

Chapter 2 Installation and Maintenance

Only trained service personnel should install and maintain the Power Supply.

Prior to installing the Power Supply, an APC approved enclosure must be installed and AC line voltage must be routed to the enclosure. Local, state, federal and/or National Electric Code (NEC) regulations regarding location, permits and electrical wiring must be adhered to.

Do not operate the Power Supply where the temperature and humidity are outside the specified limits. See Specifications in this manual.

Front View

Side View

Installing the Power Supply

Enclosure Installation

Bottom View

Line Input

Cable Adapter

Output Indicator

Ground Lug

Mounting Screw

1.Remove the screw holding the key on the rear of the chassis.

2.Remove the 10-32 Phillips mounting screw that secures the bracket to the housing.

3.Remove the mounting bracket from the housing by pulling down.

4.Set the Power Supply and the key aside.

5.Refer to Specifications in this manual for Power Supply dimensions.

3

990-5516A 10/2004

Image 5
Contents BroadBand Ctfrp Page General Information Important Safety Instructions Save These InstructionsUnpacking Electrical Warnings Overhead LiftingEnvironmental Specifications SpecificationsPhysical Specifications Models SupportedEnclosure Installation Installation and MaintenanceInstalling the Power Supply Wiring CTFRP-6XXX Series OperationCTFRP-90XXX Series Initial Start-up To shut down the Power SupplyHow to Contact APC Service, Contact and Warranty InformationService Regulatory Approval Limited Warranty