APC SUA48XLBP user manual Introduction, Specifications, About this unit, Unpack

Page 3

Introduction

About this unit

The American Power Conversion (APC®) SUA48XLBPexternal battery pack connects to the APC Smart-UPS®. Together these units provide extended protection for electronic equipment from utility power blackouts, brownouts, sags and surges. The UPS and the external battery pack together provide continuous power from the batteries until utility power returns to safe levels or the batteries are fully discharged.

Unpack

Read the Safety Guide before installing the unit.

Inspect the unit upon receipt. Notify the carrier and dealer if there is damage.

The packaging is recyclable; save it for reuse or dispose of it properly.

Check the package contents:

•External battery pack •Front bezel •Literature kit containing:

Eight ornamental screws for securing the unit in the rack

Eight 5/16 in (.8 cm) pan-head screws for attaching cleats to the chassis rails

(required for four post rack only)

Eight 5/8 in (1.6 cm) pan-head screws for attaching rack-mount brackets to the unit

Eight snap-on speed nuts

Two cleats (required for four post rack only)

Two rack-mount brackets

Product documentation

Smart-UPS®User Manuals CD

Safety information

Warranty information

Specifications

Temperature

32° to 104° F (0° to 40° C)

This unit is intended for indoor use

Operating

only. Select a location sturdy enough

Storage

5° to 86° F (-15°to 30° C) charge the batteries every six months

to handle the weight.

 

86° to 113° F (30° to 45° C) charge the batteries every three months

Do not operate the unit where there

 

is excessive dust or the temperature

Maximum

 

or humidity are outside the specified

 

limits.

Elevation

 

 

Environmental factors impact battery

Operating

10,000 ft (3,000 m)

life. High temperatures, poor utility

Storage

50,000 ft (15,240 m)

power, and frequent, short duration

 

 

discharges will shorten battery life.

 

 

 

Humidity

0 to 95% relative humidity, non-condensing

 

 

 

 

Weight

150 lbs (68 kg) with battery module

150 lbs (68 kg)

 

40 lbs (18 kg) without battery module

 

 

27 lbs (12 kg) each battery module

 

 

 

 

Maximum Number of External Battery Packs Supported by the

10

Smart-UPS XL

 

 

 

 

 

NOTE: The model and serial numbers are located on a small, rear panel label. For some models, an additional label is located on the chassis under the front bezel.

XL Tower/Rack-Mount 5U External Battery Pack User Manual

3

Image 3
Contents APC Smart-UPS→XL Page About this unit SpecificationsRead the Safety Guide before installing the unit IntroductionTower to rack-mount conversion procedure InstallationTower configuration Rack-mount configurationBattery Disconnect Strap Install unit in rack Connect the external battery packs Service Maintenance and Service InformationSetting the UPS to Recognize the Battery Packs Replacing the battery modulesTerms of warranty Two-Year Warranty