Connecting the Front I/O Ports, Water Cooling Platform

2.8 Cable Management Compartment

There is a cable management compartment between the motherboard and right side panel. You can tuck or route excess cables in this compartment.

1.Remove both side panels.

2.Choose the cables you would like to pass through the holes behind the motherboard tray and pull them out of the power supply chamber towards the right side of the case.

3.Use the cable ties provided to hold them in place.

4.Feed the cables back through the insertion point nearest the destination of the cable. Connect the cable and then pull the slack back to the right side of the case.

2.9 Water Cooling Platform

This case comes with a 5.25” metal plate pre-installed in the 3rd 5.25” drive bay. This plate is designed to allow you to easily mount components of a water-cooling kit such as a pump or reservoir. The plate can be mounted in any of the nine 5.25” drive bays for maximum flexibility.

Note: The plate is not pre-drilled. You will need to drill the appropriate holes to be compatible with your water-cooling kit.

2.10 Three-Way NVIDIA™ SLI™ Configuration Option

The Nine Hundred Two has eight expansion slots, making it capable of supporting up to three graphics cards in triple- NVIDIA™ SLI™ configuration. Consult your motherboard and graphics cards manuals for more information.

Connecting the Front I/O Ports

3.1 USB 2.0

Connect the front I/O panel USB cable to the USB header pin on your motherboard. Check the motherboard manual to ensure that it matches the table below:

9 10

Motherboard USB Pin Layout

Pin	Signal Names	Pin	Signal Names
1	USB Power 1	2	USB Power 2
3	Negative Signal 1	4	Negative Signal 2
5	Positive Signal 1	6	Positive Signal 2
7	Ground 1	8	Ground 2

9	Key (No Connection)	10	Empty Pin